Author Topic: Thoughts on cooling systems  (Read 4262 times)

Offline BONKERS

  • Newbie
  • *
  • Posts: 4
    • View Profile
  • Your Best Time: 8.55. 1/4
  • Your Engine: 396” SBC ALCOHOL INJECTED
  • Your Track: Lebanon Valley
  • Your Vehicle: Fiat Topolino Altered
  • General Location: East Coast
Thoughts on cooling systems
« on: February 10, 2022, 02:44:26 PM »
Going with a new engine combo this year.. SBC with a tunnel rammed Birdcatcher on alcohol… first time running something that wasn’t fueled by gasoline.. been searching the internet and mixed answers I’m finding.. so here is what I would like to be able to do if possible:

1/4 mile track, would like to drive to staging lanes and back up the return road after a pass.. I usually am a solo racer except for larger events and would like not have to rely on someone towing me to the pits and back.

My thoughts was to plumb up a remote water pump and a small tranny cooler type radiator that I can “hide” somewhat. From looking at some guys setups, they are using -8 or -10 lines coming in/out of the  cooler, through the pump then back to the block water pump inlets ( t’ed connection between those 2 inlets on block). Then an expansion/fill cap setup on the manifold with another line off that back to the radiator to complete the circuit.

Not sure even if A fan will be needed on the cooler. Any input will be appreciated!

-Tom

Tom Fox
GO’N BONKERS
A/A Alcohol Injected Topolino Altered
XOFMOT RACING
Brookfield Ct

Offline Supercat

  • Sr. Member
  • ****
  • Posts: 252
    • View Profile
  • Your Best Time: 6.16 @ 218 1/4
  • Your Track: Bakersfield to Bowling Green to New England dragway
  • Your Vehicle: Buick powered/ 200" Fastech FED
Re: Thoughts on cooling systems
« Reply #1 on: February 10, 2022, 04:02:32 PM »
Tom if you run a cooling system keep it small and simple.
I run an iron 462 on alchohol with no coolant.  I drive the FED to the line make a pass and then run back to my pit. In hot weather I have run a fan but rarely.   I would think a small cooling system would be plenty.

Offline BONKERS

  • Newbie
  • *
  • Posts: 4
    • View Profile
  • Your Best Time: 8.55. 1/4
  • Your Engine: 396” SBC ALCOHOL INJECTED
  • Your Track: Lebanon Valley
  • Your Vehicle: Fiat Topolino Altered
  • General Location: East Coast
Re: Thoughts on cooling systems
« Reply #2 on: February 10, 2022, 04:54:47 PM »
That has been my thought as well.. I just feel having some “cooling”  system will give me a little piece of mind. I might be a bit more brave if it was a big block.. it’s just these small blocks with those 2 center exhaust ports next to each other makes me feel a bit “worried “ with no additional cooling going on if I run the block dry. Better safe than sorry they say!! Lol
Tom Fox
GO’N BONKERS
A/A Alcohol Injected Topolino Altered
XOFMOT RACING
Brookfield Ct

Offline BK

  • Sr. Member
  • ****
  • Posts: 310
    • View Profile
  • Your Best Time: 8.45 / 5.30
  • Your Track: Empire Dagway
  • Your Vehicle: Late 70's FED
Re: Thoughts on cooling systems
« Reply #3 on: February 10, 2022, 06:39:27 PM »
I had a similar setup to yours at one point.
It was OK most of the time but if I went rounds and the pace picked up it wasn't quit enough.
If you set idle a little rich it will help by cooling off on the way back. But you end up with a lot of moisture in the oil pan.
I have a radiator out of a Honda Civic now and that seems to be enough. And I can keep he engine on the leaner side.

Offline Supercat

  • Sr. Member
  • ****
  • Posts: 252
    • View Profile
  • Your Best Time: 6.16 @ 218 1/4
  • Your Track: Bakersfield to Bowling Green to New England dragway
  • Your Vehicle: Buick powered/ 200" Fastech FED
Re: Thoughts on cooling systems
« Reply #4 on: February 11, 2022, 04:36:12 AM »
Tom I run a BB Buick so exhaust is similar.

Offline dusterdave173

  • Hero Member
  • *****
  • Posts: 638
    • View Profile
  • Your Best Time: 5.38in 1/8th
  • Your Engine: 355 CI SBC
  • Your Track: Mooresville, NC
  • Your Vehicle: CenPen 200 inch FED
Re: Thoughts on cooling systems
« Reply #5 on: February 12, 2022, 06:31:26 AM »
Idling back up the return road etc the unit is Rich and Cool--If you are lapping then yup cool her off but I never had cooling drove mine around like I did  and never had an issue--You can't get stuck behind someone blocking the lanes--I used the throttle as a Horn--rump! rump! get out of the way!
Cooling system? then you have water under the tires if you hurt it--or in your face
I have always had a fascination with fast cars at the expense of more normal character development

Offline JEFF/21C

  • Full Member
  • ***
  • Posts: 122
    • View Profile
  • Your Best Time: N/A
  • Your Engine: 306 SBC INJECTED ALKY
  • Your Track: NONE
  • Your Vehicle: 23 T ALTERED
  • General Location: eastern canada
Re: Thoughts on cooling systems
« Reply #6 on: February 12, 2022, 04:23:11 PM »
Had a rad, fan and a aluminum water pump running a half speed  when the fed ran on gas switched to alky  removed the fan and rad ran a hose between the inlet and outlet  had to shut the motor down waiting in line did burn-out ran and returned no problem temp dropped going down the track. no problem making back to back runs

Offline lake_harley

  • Sr. Member
  • ****
  • Posts: 262
    • View Profile
  • Your Best Time: 7.06 @99.58 - 1/8 mi.
  • Your Engine: Carbureted, gas mild 305 Chevy
  • Your Track: Jeffers Motorsports Park - Sikeston, MO
  • Your Vehicle: 145" FED
  • General Location: SE Missouri
Re: Thoughts on cooling systems
« Reply #7 on: February 12, 2022, 05:04:33 PM »
BK....I'm concerned about cooling and have posted in a thread in the FED section about bracket racing a FED. By what I've found searching online, the Honda Civic radiator ('92 to '00 something?) is about 14" X 16" or 17"....is that about the size of the radiator you're talking about? I'll be running a mild 305 Chevy on gas and want to be able to "lap" it, rather than having to tow it back. I figured I'd run a electric pump and fan to cool between rounds as needed. Picture(s) of your arrangement would be great if you could post a photo or two.

Thanks

Lynn

Offline THE FRENCHTOWN FLYER

  • Sr. Member
  • ****
  • Posts: 360
    • View Profile
  • Your Best Time: 8.28@168 door; 9.00@147 6-cyl alt; 8.53@160 RED
  • Your Engine: 300 Ford six NA w/ crossflow and prod. heads
  • Your Track: Milan, Thompson
  • Your Vehicle: (3) Advanced Chassis altered , The Last Logghe altered, '30 RPU
  • General Location: North Coast
Re: Thoughts on cooling systems
« Reply #8 on: February 13, 2022, 06:53:35 AM »
...I used the throttle as a Horn--rump! rump! get out of the way!
...
All my race cars have a small motorcycle horn. Sometimes spectators are oblivious to a race car approaching frombehind, and even less aware that there could be cooling / fouling issues if the car is left idling while they saunter down the lanes.
Likewise, I have two small headlights for night racing for the same reason.

Offline Curly1

  • Sr. Member
  • ****
  • Posts: 260
    • View Profile
    • AireTex Compressors
  • Your Best Time: 7.95 @ 167 1/4 mile
  • Your Track: Texas Motorplex
  • Your Vehicle: 125" Altered
Re: Thoughts on cooling systems
« Reply #9 on: February 27, 2022, 07:38:31 PM »
I built several of my cars with the Honda style aluminum radiators. You can get them on Ebay cheap and they are nice. I do run a fan with a thermostat controller so when it gets temp I want fan comes on. I can turn it off when I want to build heat. On my new car I put a oil cooler type radiator but have yet to try it.

Offline slingshot383

  • Full Member
  • ***
  • Posts: 143
    • View Profile
  • Your Best Time: 1/4 mi. 7.95 @ 168
  • Your Engine: Chrysler, alcohol, 528 cu.in.
  • Your Track: Gateway Motorsports Park (the Swamp)
  • Your Vehicle: Undercover Chassis 23T altered
Re: Thoughts on cooling systems
« Reply #10 on: November 22, 2022, 02:49:14 PM »
Electric remote water pump, large Hayden tranny cooler will do you just fine running alcohol.
Undercover 23T Altered, big block Mopar
Member of the Torque and Recoil Club