Author Topic: Nostalgia FED For sale Updated 6-2-2021 Everything SOLD  (Read 1697 times)

Offline sknopp

  • Newbie
  • *
  • Posts: 41
    • View Profile
  • Your Best Time: 7.008@215 on 7.00 Index
  • Your Track: Bowling Green
  • Your Vehicle: 1969 MW 214" FED
Nostalgia FED For sale Updated 6-2-2021 Everything SOLD
« on: May 05, 2021, 12:09:14 PM »
Nostalgia FED for Sale; car, trailer, listed spares: $35,000.00 OBO
Steve Knopp sknopp@mppinnovation.com
812-755-six seven nine two (day)
812-896-six three five four (eve)
Located in Salem, In.

Car:
1969 Mark Williams 214" FED serial no. 20550; SEMA tag 1535
SFI 2.4 (6.29) cert. good until 7/2023
Shoulder hoop 19-1/2" CL to CL; motor out 31-1/2 to axle centerline
Hayden front spoke rims with GoodYear front runners 17 X 22
ETIII Slots rear with MT 14.5 X 32 X 15
398 CI 417 Donovan #55 block.  4.030 Darton sleeves
Crower billet crank, 3.906 stroke, std mains, 426 rod journals
Titan gerotor oil pump
MGP H3000 aluminum rods
Arias 6:1 pro coated fuel pistons
Iron 392 heads, Manley valves; 2.125 int, 1.940 ex
Stk 392 int rockers w/roller brg.; Harvey Aluminum Gotha adj. exh rocker w/roller brg.
Smith Bros pushrods
Littlefield 6-71 Blower with strips
Enderle 3 rib nostalgia injector hat w/K bbl valve; hat & port nozzles
Enderle 990 fuel pump; hi/low bypass
FIE SuperMag V with monster coil
Offset mag drive, custom hex mag/oil pump driveshaft (eliminates tang)
Lakewood 8-1/8 steel clutch can
AFT 11", 12 stand 3 disc aluminum pedal clutch, fresh grind
Lenco magnesium reverser
8-3/4 742 rear end with 4.10 gears
Strange spool, 35 spline axles, discs and calipers
Dual Taylor 12' chutes with chrome packs
RJS seat belts
Deist blower restraint and reverser blanket
New DRE diaper
Dan Olson pan & zoomies
All certs current
Set up for 70-80% nitro
Trailer:
1997 Avenger 24' dual axle
2 new 3500 lb axles
2 new load range D tires & rims
2 recent load range D tires and rims
2 load range C tires and rims
Tire Minder
12V 2000 lb winch
8' flourescent interior lights plus 2 12V lights
Finished walls, checkered linoleum floor
Load leveling hitch
Tire minder monitor system
2 new spare 10" brake assemblies
4 new spare brake shoes
Spares that go with car:
36V battery cart & starter
Warm up stand
Original front spoke wheels w/Goodyear 17 X 22 front runners
Between rounds vapor ventilator
2 spare rear tubes
2 used 9 X 9 chrome chute packs
8 used Darton 4.030" sleeves
3 sets used K Motion K900 valve springs
1 set 61 run valves (need cleaned up)
1 set spare heads with valves (cracked but usable)
1 set heads with valves (cracked-not usable but valves good)
3 sets used MGP rods 20-32 runs
1 set used MGP rods 4 runs (some dinged up)
4 sets used Arias 4.030 6:1 Pro Coated pistons (scuffs, could build spare set)
6 spare used floaters ready to run
1 box used discs (.250-.300 thick)3 new Ram 5191 11" discs 1-3/8-10
Donovan oil pump & splined driveshaft
1 set used Isky roller lifters
4 spare Harvey Aluminum Gotha adjustable exh rockers with roller bearings
2 spare intake rockers with roller bearings
3 spare Smith Brothers adjustable intake pushrods
3 spare Smith Brothers exhaust pushrods
2 complete sets used rubber port hoses
1 complete set new spare stainless hat hard lines
1 used spare SuperMag cap
1 used spare SuperMag cap with complete set hemi wires
1 complete set new hemi plug wires
1 spare used Mallory red top coil
1 spare used Mallory black top coil
1 set spare used brake disc pads, hard
1 spare new AutoMeter 300 PSI oil pressure gage with stainless hose and AN fittings
1 20 run spare 8MM GT 1440-75 Kevlar blower belt
1 28 run spare 8MM GT 1440-75 Kevlar blower belt
Many 30-50 run 8MM GT 1440-75 Kevlar blower belts
3 new throw out bearings
2 sets spare custom hex oil pump/mag drive assemblies
Driveshaft and cover for direct drive (no reverser)
Clutch weight/shim/setting tool kit/tungsten weights, bolts, nuts, washers
1 complete set Titanium fixed clutch stands
1 complete set Aluminum fixed clutch stands
1 complete set steel adjustable clutch stands
Spare intake and valley cover gaskets
Diaper pads
1 new spare Mark Williams rear coupler
8mm HTD blower pulley

Spares available:with car-will sell separately after car sells:
8mm GT blower pulley 46T  $25.00 w/car; $50.00 separately
8mm GT blower pulley 47T  $25.00 w/car; $50.00 separately
8mm GT blower pulley 57T  $25.00 w/car; $50.00 separately
8mm GT blower pulley 60T  $25.00 w/car; $50.00 separately
8mm GT blower pulley 63T  $25.00 w/car; $50.00 separately
8mm GT blower pulley 65T  $25.00 w/car; $50.00 separately
(94) new NGK R5671A-9 plugs  $.75 ea. w/car;  $1.50 ea. separately
(100) new NGK R5671A-10 plugs  $.75 ea. w/car;  $1.50 ea. separately
(19) new Clevite CB1512V STD rod bearings $150.00 w/car;  $190.00 separately
(19) cases Kendall Nitro 70 oil $20.00/case w/car;  $30.00/case separately
(1) new Taylor pilot chute  $25.00 w/car;  $50.00 separately
(1) new nitro beaker $10.00 w/car;  $20.00 separately
(1) new nitro hydrometer 1.00-1.200 range $15.00 w/car;  $25.00 separately
(1) Kinsler Alky/Nitro Hydrometer set .65-1.00 & 1.00-1.200 $35.00 w/car; $50.00 separately
(1) backup hydrometer set .800-1.00 & .900-1.00 $20.00 w/car;  $35.00 separately
(1) FIE Supermag V with new pro cap CW rotation $250.00 w/car; $475.00 separately
(1) FIE Supermag+ fresh from FIE new monster cap CW rotation $375.00 w/car; $675.00 sep
(1) new 8-3/4 742 nodular iron bare case, never assembled $250.00 w/car; $375.00 separately

« Last Edit: June 02, 2021, 04:50:15 AM by sknopp »