« previous next »
Pages: [1]   Go Down

Author Topic: Vaccuum Pumps  (Read 2308 times)

Offline spitzerscott

  • Full Member
  • ***
  • Posts: 116
    • View Profile
    • Ogg Motorsports
  • Your Best Time: 5.73@118.80
  • Your Engine: 336 Small Block Chevy
  • Your Track: Osceola IN, Top Eliminator runs 1/8 mile
  • Your Vehicle: Spitzer225 RED, Alcohol SBC
  • General Location: Northern Indiana
Vaccuum Pumps
« on: November 27, 2020, 01:13:21 PM »
I am putting a Moroso 3 vane vacuum pump on my 336 SBC alcohol engine. Can anyone tell me about how many inches of vacuum I will want to pull?
Logged

Offline MaggiFinn

  • Jr. Member
  • **
  • Posts: 54
    • View Profile
  • Your Engine: SBC 355-406
  • Your Track: Kvartmiluklubburinn
  • Your Vehicle: FED
Re: Vaccuum Pumps
« Reply #1 on: November 27, 2020, 02:41:44 PM »
Here's a note from David Reher, of Reher-Morrison

On the dyno, we see fluctuations in oil pressure when the crankcase vacuum approaches 15 inches with a wet-sump system. We use an adjustable air bleed (essentially a controlled leak) to regulate the maximum pan vacuum to between 10 and 12 inches. With the wet-sump system we install on our Super Series bracket racing big-blocks, we see no fluctuations in oil pressure at this vacuum.

https://rehermorrison.com/tech-talk-24-panning-for-power/
Logged
Pages: [1]   Go Up
« previous next »