Author Topic: Oil temp  (Read 2874 times)

Offline retroboy

  • Full Member
  • ***
  • Posts: 221
    • View Profile
  • Your Track: Whyalla
  • Your Vehicle: FED
Oil temp
« on: July 02, 2019, 07:25:39 AM »
Hello
Just wondering what temp your oil is? I have had some bearing issues and been using 20/50 oil and looking to go to a 10/40 and just thinking the engine oil may not have been hot enough?  I run methanol and no cooling so I was looking at putting a temperature probe in the remote oil filter adaptor.
Cheers

dreracecar

  • Guest
Re: Oil temp
« Reply #1 on: July 02, 2019, 09:44:32 AM »
I use Brad Penn oil (50w) as it does not emulsify (mix) with the alc.  Run a test with a hand blender, put a qt (liter) in a pot and a touch of alc and mix. see how long it takes to separate, if it does not , theres your problem, you have weakened the oil

Offline wideopen231

  • Hero Member
  • *****
  • Posts: 1911
    • View Profile
  • Your Best Time: 1/8 3.70@ 198 1/4 5.78@245
  • Your Engine: Hemi 526 ci alcohol
  • Your Track: Piedmont
  • Your Vehicle: 225 CMC FED
  • General Location: NORTH CAROLINA
Re: Oil temp
« Reply #2 on: July 03, 2019, 06:31:15 PM »
I run temp sensor in Pan,heads and outlet side of oil cooler. I run one gauge with 3 positon switches that allow me to read all separately with flip of a swtich or two. I use electric sensor not probe for this. Can compare temps in 3 seconds.
Relecting obama is like shooting right foot because it did not hurt enough when you shot left foot

Offline masracingtd1167

  • Hero Member
  • *****
  • Posts: 1110
  • bill masiello Shelton Ct.
    • View Profile
  • Your Best Time: 7.40's at 181 on motor 6.94 at 192 nitrous
  • Your Engine: 394 chevy
  • Your Track: Lebanon Valley Dragway
  • Your Vehicle: 2003 Neil and Parks
Re: Oil temp
« Reply #3 on: July 04, 2019, 04:44:25 AM »
I run the Brad Penn oil as well and would highly recomend it ! If you are having bearing problems something else might be wrong !