Author Topic: front wheel cradels  (Read 3485 times)

Offline noslin

  • Sr. Member
  • ****
  • Posts: 259
    • View Profile
  • Your Best Time: 0.00
  • Your Engine: none
  • Your Track: none
  • Your Vehicle: none
  • General Location: west coast
front wheel cradels
« on: June 16, 2017, 05:58:54 PM »
Those of you who tow more then 100 miles to the track, thoughts on front wheel cradles.

Dean

Offline sknopp

  • Newbie
  • *
  • Posts: 41
    • View Profile
  • Your Best Time: 7.008@215 on 7.00 Index
  • Your Track: Bowling Green
  • Your Vehicle: 1969 MW 214" FED
Re: front wheel cradels
« Reply #1 on: June 19, 2017, 09:51:03 AM »
Dean,

I put wooden "V" blocks under each side of the front axle to keep the front tires up off the floor.  And for sure use a chassis saver or some other means to support the frame.
Steve K.

Offline Paul New

  • Hero Member
  • *****
  • Posts: 743
    • View Profile
  • Your Best Time: 6.47 @ 214 MPH SBC
  • Your Engine: 387" SBC
  • Your Track: Woodburn Dragstrip
  • Your Vehicle: 2005 FED
Re: front wheel cradels
« Reply #2 on: June 19, 2017, 09:59:09 AM »
I use to run a pair of the chassis shop rubber ones but haven't used any with our new trailer I have them sitting on the shelf

Offline gregm784

  • Sr. Member
  • ****
  • Posts: 384
    • View Profile
    • Means Racing
  • Your Engine: 365" GenIV SBC
  • Your Track: Famoso Raceway
  • Your Vehicle: 1997 Stirling 200" FED
Re: front wheel cradels
« Reply #3 on: June 19, 2017, 03:19:12 PM »
I tie down over the rear slicks (air'd up to 12psi) and tie down the center of the car.  Front end never moves.
Greg
El Dorado County, CA
www.meansracing.com