« previous next »
Pages: [1]   Go Down

Author Topic: Port Nozzle Design  (Read 2889 times)

Offline captndiet

  • Newbie
  • *
  • Posts: 35
    • View Profile
  • Your Track: Rogersville Missouri
  • Your Vehicle: Front Engine Dragster
Port Nozzle Design
« on: March 23, 2017, 12:55:31 PM »
Anyone familiar with this port nozzle holder design?

The square cuts are on both sides and they vent up into where the nozzle screws in.

Jeff
Logged

Offline BK

  • Sr. Member
  • ****
  • Posts: 310
    • View Profile
  • Your Best Time: 8.45 / 5.30
  • Your Track: Empire Dagway
  • Your Vehicle: Late 70's FED
Re: Port Nozzle Design
« Reply #1 on: March 23, 2017, 04:08:10 PM »
Pretty sure the slots are the air bleeds. Keeps dirt out that way.
Logged

Offline captndiet

  • Newbie
  • *
  • Posts: 35
    • View Profile
  • Your Track: Rogersville Missouri
  • Your Vehicle: Front Engine Dragster
Re: Port Nozzle Design
« Reply #2 on: March 24, 2017, 06:21:21 PM »
A normal aspirated nozzle holder would have the hole outside the the hat or port.

These would be pulling the air from inside the hat or port.

Jeff
Logged
Pages: [1]   Go Up
« previous next »