Author Topic: Wide Band O2 tuning for an FED  (Read 7621 times)

Offline MikenMpls

  • Jr. Member
  • **
  • Posts: 80
    • View Profile
  • Your Engine: 408 dart little m block and Iron Eagle heads
  • Your Track: Cameron, MO
  • Your Vehicle: 205" FED
Wide Band O2 tuning for an FED
« on: January 03, 2016, 12:50:25 PM »
Has anyone played with using a wide band O2 sensor and gauge to tune their 8 stack injector (on Alcohol)?  Knowing that most of these devices have data recording capabilities it seems plausible that using one could help tune all aspects of the fuel curve (idle to full throttle). All of you have tried most everything at least once ,what were your experiences with this? Thanks!

Offline ricardo1967

  • Hero Member
  • *****
  • Posts: 570
    • View Profile
  • Your Best Time: No full pass yet.
  • Your Engine: Alky SBC 400
  • Your Track: Brown County Dragway (Bean Blossom, IN)
  • Your Vehicle: 173" FED
Re: Wide Band O2 tuning for an FED
« Reply #1 on: January 03, 2016, 01:06:42 PM »
Mike, do you mean one O2 sensor per pipe (8 total)?

Offline wideopen231

  • Hero Member
  • *****
  • Posts: 1911
    • View Profile
  • Your Best Time: 1/8 3.70@ 198 1/4 5.78@245
  • Your Engine: Hemi 526 ci alcohol
  • Your Track: Piedmont
  • Your Vehicle: 225 CMC FED
  • General Location: NORTH CAROLINA
Re: Wide Band O2 tuning for an FED
« Reply #2 on: January 03, 2016, 02:02:42 PM »
Lots using them.Most for injection and carb run one.While one will work if you use plugs to tune cylinders to be equal.8 would be optimal or one with 8 egt's.I use EGT's.Thing with using them is you have to understand there is no magic number.While one car may be perfect at 1200* the next may need 1300 or 1050.They are great for keeping check on system and as referance as to what is happening compared to other runs..
Now there are folks who swear by O2 and hate egt's.Like other things its what you are use to and how you use them.
If you can not use data recorder per rules then a O2 maybe perfect and if nothing else it will get you real close on system.
Relecting obama is like shooting right foot because it did not hurt enough when you shot left foot

dreracecar

  • Guest
Re: Wide Band O2 tuning for an FED
« Reply #3 on: January 04, 2016, 08:07:59 AM »
First you must understand that alcohol is not gas and a sloppy fuel the way we use it.  Alc is also not a complete burn since it is consumed as a liquid and not a vapor(like gas). I believe the sensor would get overwelmed buy the amount of raw fuel left over in the exhaust. Exhaust heat out the port is a better way to moniter tuning.
 Very few things are new in the tuning world and if there was a way to use multiple 02 sen's it would already be out there on the market

Offline oldmanreo

  • Newbie
  • *
  • Posts: 1
    • View Profile
  • Your Best Time: 8.16
  • Your Engine: sbc gas 389
  • Your Track: cecil county
  • Your Vehicle: fed
  • General Location: ec
Re: Wide Band O2 tuning for an FED
« Reply #4 on: January 09, 2016, 06:08:09 PM »
all pro stock team and many comp. racers use o2 to tune their engines
include pro mod also .if i had the money i would use o2.as for alh. being a liquid
in the cyl.chamber i belive tht it would hydraulic the engine

dreracecar

  • Guest
Re: Wide Band O2 tuning for an FED
« Reply #5 on: January 09, 2016, 06:57:53 PM »
All those classes run gas, not alcohol
YouTube the video of a nitro fuel pump demonstration, alc is the same, just less volume

Offline masracingtd1167

  • Hero Member
  • *****
  • Posts: 1110
  • bill masiello Shelton Ct.
    • View Profile
  • Your Best Time: 7.40's at 181 on motor 6.94 at 192 nitrous
  • Your Engine: 394 chevy
  • Your Track: Lebanon Valley Dragway
  • Your Vehicle: 2003 Neil and Parks
Re: Wide Band O2 tuning for an FED
« Reply #6 on: January 10, 2016, 10:18:52 AM »
all pro stock team and many comp. racers use o2 to tune their engines
include pro mod also .if i had the money i would use o2.as for alh. being a liquid
in the cyl.chamber i belive tht it would hydraulic the engine
     When you run alcohol you have to be carefull that you don't close your intake valve too early . With all of the extra liquid in the cylinder it can raise your dynamic compression too high and cause engine damage . As far as the o2 goes the cost to monitor 02 for each cylinder would be through the roof ! The best method I have found for tuning is to monitor engine temp . If it won't build heat during a run it is too rich . If it builds too much heat it is too lean . Pretty simple but it works . Bill

Offline JrFuel Hayden

  • Hero Member
  • *****
  • Posts: 600
    • View Profile
    • Hayden Enterprises Speciality Wheels
  • Your Best Time: 6.02, 236 mph, 1/4 in 1973 Div 3 TF Champ
  • Your Engine: SBC, Alky, 403 ci, Best 6.99 @ 190 & 409 Hemi
  • Your Track: Bakersfield
  • Your Vehicle: 225" FED NHRA Heritage Jr Fuel
Re: Wide Band O2 tuning for an FED
« Reply #7 on: January 10, 2016, 06:08:46 PM »
I have talked to at least 3 teams racing alky that have tried, with no sucess, or help with O2 sensores .
 They seem to help with gas, but not alky. 
 Still the best is reading spark plugs, and ET slips.
Yes, engine temps help, but you can build real good temp by leaning the barrel valve, but to check temp build up, check the engine temp with a temp gun after the run.
 I try to get my engine temp to 180° to 200° while staging the car, [ with water in the block/ heads, 160° dry]  alky burns better with a hot engine.
I know some bracket racers that change their engine temp to run the number, cooler to slow down, hotter to run quicker.

Jon Hansen, JrFuel Dragster Association
Jon C. Hansen

Hayden Wheels

Offline slingshot383

  • Full Member
  • ***
  • Posts: 143
    • View Profile
  • Your Best Time: 1/4 mi. 7.95 @ 168
  • Your Engine: Chrysler, alcohol, 528 cu.in.
  • Your Track: Gateway Motorsports Park (the Swamp)
  • Your Vehicle: Undercover Chassis 23T altered
Re: Wide Band O2 tuning for an FED
« Reply #8 on: January 13, 2016, 10:48:07 AM »
You can do O2 with collector header and alcohol, but zoomies don't have enough length.  While temp probes are typically 2" from the head, O2 sensors are usually 8" or more from the head.
Undercover 23T Altered, big block Mopar
Member of the Torque and Recoil Club

Offline wideopen231

  • Hero Member
  • *****
  • Posts: 1911
    • View Profile
  • Your Best Time: 1/8 3.70@ 198 1/4 5.78@245
  • Your Engine: Hemi 526 ci alcohol
  • Your Track: Piedmont
  • Your Vehicle: 225 CMC FED
  • General Location: NORTH CAROLINA
Re: Wide Band O2 tuning for an FED
« Reply #9 on: January 13, 2016, 11:08:38 AM »
what is this collector you speak of sligshot? Is it like one of those carb things? Urban legend.
Relecting obama is like shooting right foot because it did not hurt enough when you shot left foot

Offline slingshot383

  • Full Member
  • ***
  • Posts: 143
    • View Profile
  • Your Best Time: 1/4 mi. 7.95 @ 168
  • Your Engine: Chrysler, alcohol, 528 cu.in.
  • Your Track: Gateway Motorsports Park (the Swamp)
  • Your Vehicle: Undercover Chassis 23T altered
Re: Wide Band O2 tuning for an FED
« Reply #10 on: January 20, 2016, 10:27:32 AM »
It be those long headers that all four tubes get squeezed into one tube.......Not at all like those nice flowing individual pipes that just curl up and back from the exhaust ports!
Undercover 23T Altered, big block Mopar
Member of the Torque and Recoil Club

Offline masracingtd1167

  • Hero Member
  • *****
  • Posts: 1110
  • bill masiello Shelton Ct.
    • View Profile
  • Your Best Time: 7.40's at 181 on motor 6.94 at 192 nitrous
  • Your Engine: 394 chevy
  • Your Track: Lebanon Valley Dragway
  • Your Vehicle: 2003 Neil and Parks
Re: Wide Band O2 tuning for an FED
« Reply #11 on: January 20, 2016, 12:08:29 PM »
Now guy's some of us run those funny pipes

Offline wideopen231

  • Hero Member
  • *****
  • Posts: 1911
    • View Profile
  • Your Best Time: 1/8 3.70@ 198 1/4 5.78@245
  • Your Engine: Hemi 526 ci alcohol
  • Your Track: Piedmont
  • Your Vehicle: 225 CMC FED
  • General Location: NORTH CAROLINA
Re: Wide Band O2 tuning for an FED
« Reply #12 on: January 20, 2016, 04:56:55 PM »
consider the soure of the picture above.Enough said.LMAO
Relecting obama is like shooting right foot because it did not hurt enough when you shot left foot