1
Gassers / Re: Introduction
« on: November 30, 2016, 08:51:24 PM »
Thank you. Rollbars are required after certain ets. My car is updated a lot from these pictures, I'm trying to find some to post.
FEDs Forever!
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
4
Matt Shaff's Engine Shop / Re: BBC stud girdles
« on: November 21, 2016, 10:26:13 PM »Does anyone here know what stud girdle will fit BBC pro comp heads? I ordered one from procomp and it won't work on their own heads. So now I really don't know which one to try. I'm running out of time before winter is going to shut me down for the year
Hello, how don't they fit? This is my experience.
I have brodix bb2 plus heads , I used comp cams gold rockers and jomar girdles. jomar girdles wouldn't work, the rockers hit the girdles no matter what I did. I installed brodix stud girdles and had no problem. NOt so tall rockers, maybe like Harland sharps, would have cleared with the jomars.
5
Matt Shaff's Engine Shop / Re: Pouring an engine block after it has been bored
« on: November 21, 2016, 10:10:41 PM »
There, I have been wondering about filling my block after machining and how to drain the water afterwards. Now I know.
I do wonder if the block filler is ruined by cooling fluid or oils, if you have more machine work done?
I do wonder if the block filler is ruined by cooling fluid or oils, if you have more machine work done?
6
Gassers / Re: Introduction
« on: November 21, 2016, 09:49:45 PM »
Thank you. I'm lucky to have fellow racers updating their cars, so I buy their used parts .
Not having tons of money in my car makes it more fun to me. Not having luck posting pictures, but I'll get it soon.
Specs: used BBC 454 stock block + .06 , used stock cast crank
used ls6 pistons, new procomp rods, used comp cams roller 680/680, used crower lifters
new brodix bb-2 plus rectangle heads. used dart open plenum intake
used 850 holley, new strange 4.86 gears w/ full spool, new hoosier 29 9 15 slicks
new MSD ignition 6400 rev limit , rebuilt Muncie m20 trans w/ used hurst vgate shifter.
Not having tons of money in my car makes it more fun to me. Not having luck posting pictures, but I'll get it soon.
Specs: used BBC 454 stock block + .06 , used stock cast crank
used ls6 pistons, new procomp rods, used comp cams roller 680/680, used crower lifters
new brodix bb-2 plus rectangle heads. used dart open plenum intake
used 850 holley, new strange 4.86 gears w/ full spool, new hoosier 29 9 15 slicks
new MSD ignition 6400 rev limit , rebuilt Muncie m20 trans w/ used hurst vgate shifter.
7
Gassers / Introduction
« on: November 17, 2016, 09:47:46 PM »
Hello, I'm new to this site. Wow it has a lot of good information. I am looking forward to learning.
I have a 55 chevy I run with the Gassah Guys at Winterport Dragway in Maine. My best is 6.86 @101.15 BBC , Muncie 4 speed.
I have a 55 chevy I run with the Gassah Guys at Winterport Dragway in Maine. My best is 6.86 @101.15 BBC , Muncie 4 speed.
Pages: [1]