1
Front Engine Dragsters / Re: FRONT ENGINE DRAGSTER TRAILER FOR SALE FULLY RESTORED
« on: October 21, 2014, 11:58:34 AM »
Still have trailer for sale? pics and price to rickhuckabee@gmail.com
FEDs Forever!
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Your Builds / Photo Gallery / Engine fitment
« on: May 02, 2013, 05:48:32 PM »
>:(Well, trimming the block to work in chassis I found one some what expected oil galley and a totally unexpected water jacket.
3
Your Builds / Photo Gallery / Re: Trial fit of new motor
« on: April 27, 2013, 08:34:37 PM »
Scat Crank, Diamond pistons, GRP rods, Comp Cams Blower Cams, 3.567 Bore x 3.75 Stroke. Just under 300 cubic inches. Built my own manifold, fuel pump drive and crank support system.
4
Your Builds / Photo Gallery / Re: Trial fit of new motor
« on: April 27, 2013, 06:59:41 AM »
We will run Methanol.
5
Your Builds / Photo Gallery / Trial fit of engine
« on: April 25, 2013, 09:01:05 PM »
one more view
6
Your Builds / Photo Gallery / Trial fit of engine
« on: April 25, 2013, 08:59:55 PM »
Another view.
7
Your Builds / Photo Gallery / Trial fit of new motor
« on: April 25, 2013, 08:58:40 PM »
How many of you guys remember the "Zingers" on the early 70's car show circuit? That is what came to mind on this first trial fit.
8
Your Builds / Photo Gallery / Re: New motor for my FED
« on: March 29, 2013, 07:23:35 PM »
We are in the same boat, There is nothing made for these mod motors but it is a challenge and I think the visual impact is killer(I hope it will run). A couple of friends of mine or real pontiac nuts: Monty Ditmer of Montiac Motorsports, montiac2000@hotmail.com and Brad Thompson, His info is on his Facebook page. He has an altered wheelbase GTO that is pretty cool.
9
Your Builds / Photo Gallery / Update on blown 4.6 mod motor
« on: March 28, 2013, 09:17:51 PM »
Got the crank support roughed in and started on the manifold.
10
Your Builds / Photo Gallery / New motor for my FED
« on: February 07, 2013, 05:02:07 PM »
This is my new motor for my dragster, 4.6 DOHC Ford. Hopefully I can get the manifold,crank support, motor plate and trans adapter built and the motor and trans installed before the season begins.
Pages: [1]