1
Rear Engine Dragsters / Re: Rear engine dragster chassis update
« on: June 17, 2017, 04:14:19 PM »
Go to my Facebook site for pictures. Bob George
FEDs Forever!
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1] 2
2
Rear Engine Dragsters / Re: Rear engine dragster chassis update
« on: June 02, 2017, 05:52:00 PM »
I will post pictures in a few days
3
Rear Engine Dragsters / Re: Rear engine dragster chassis update
« on: May 29, 2017, 02:29:10 AM »
They ground the chrome off,the update was done at S&W ,they also certified the chassis for 7.50,this was done before i bought it.
4
Rear Engine Dragsters / Re: Rear engine dragster chassis update
« on: May 26, 2017, 10:00:02 AM »
Yes Paul it has 1inch helmet bars.
5
Rear Engine Dragsters / Re: Rear engine dragster chassis update
« on: May 26, 2017, 07:38:34 AM »
Thank You
6
Rear Engine Dragsters / Rear engine dragster chassis update
« on: May 25, 2017, 07:16:00 AM »
I have an older S&W re dragster with currant 7.50 tag, what would it take update the chassis to run a 7.00 class,also is a chrome roll bar acceptable.
7
Altereds / Re: Altered Safety
« on: November 03, 2016, 06:47:09 PM »
Try dragster supply for the driveshaft shield they have one,google for toll free number
8
Roo Man's Room / Re: Altered chassis question
« on: May 20, 2016, 09:51:18 AM »
All set, i was able to get the 1.375x095 cm from Shapiro Steel,i still dont understand SFI calling for 1.250xo58.Thanks everyone for your help.
11
Roo Man's Room / Altered chassis question
« on: May 19, 2016, 12:10:57 PM »
I am building an altered useing both the Mark Wiliams blueprint and the SFI chassis specs10.2 for6.00 =7.49seconds e.t..My question is the rear uprights that connects the bottom rail to the shoulder hoop the one that connects the rearend to the chassis.SFI calls for inch and a quarterx0..58 M.W.AA calls for inch and 3 eights x 095,which one do you guys prefer.
12
Roo Man's Room / Re: Chassis print
« on: April 27, 2016, 11:52:09 AM »
ThankYou for the advice,ordered the SFI deal.
13
Roo Man's Room / Chassis print
« on: April 26, 2016, 07:48:37 AM »
Could someone tell me if the Mark Williams chassis blue print for a funny car chassis is up to date,print #15101 if it is up to date what will it cert for. Thank You.
15
Wanted to buy / Funny Car Seat
« on: March 30, 2016, 01:24:09 PM »
Looking for a funny car seat aluminum,fiberglass or carbonfiber.
Pages: [1] 2