1
Spud Miller's Cave / Opinions
« on: July 14, 2017, 07:56:56 PM »
😎
FEDs Forever!
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
2
Front Engine Dragsters / Re: What did you do on your Front Engine Dragster TODAY?
« on: July 02, 2017, 04:30:01 PM »
Getting fuel lines and pump set up. Getting close. 😎
3
Front Engine Dragsters / Re: Oil Filters
« on: June 23, 2017, 04:55:44 PM »
Yes, thinking of getting one. Nice way to check screen for any metal.
5
Front Engine Dragsters / Re: Oil Filters
« on: June 22, 2017, 04:20:41 PM »
Little pricey,but very nice.
6
Front Engine Dragsters / Re: Glenn wins procomp at Memphis
« on: June 13, 2017, 08:11:31 PM »
Congratulations !
7
Spud Miller's Cave / Re: Evac
« on: May 31, 2017, 06:39:47 PM »
I run Brad Penn oil and really appreciate everyone's input.
8
Spud Miller's Cave / Evac
« on: May 30, 2017, 05:26:16 PM »
Have a SBC with Enderle injection with bug (Alky). I have a evac system running from my exhaust ( see picture) . My question is will this work good enough for this set up ? I know some recommend a vacuum pump, but the dollars are a little short with getting this set up. One guy told me this would help cut down on milky oil.
9
Front Engine Dragsters / Re: cooling question
« on: May 07, 2017, 03:29:09 PM »
Mine was flat and never had a problem. I did check the water here and there to make sure it was full, but worked great. I am running alky now,so no longer need.
11
Matt Shaff's Engine Shop / Coolant Question
« on: April 29, 2017, 11:25:59 AM »
I am going to Enderle injection (Alky) and wanting to block off water pump outlets . What would be your recommendation ? I am running a belt drive fuel pump that will bolt up to water pump mounting holes.
Thanks
Thanks
12
Front Engine Dragsters / Re: Finally Got The Car On The Track
« on: April 28, 2017, 03:55:11 PM »
Nice ride 😎
13
Matt Shaff's Engine Shop / Re: Changing over from injection too carburator
« on: April 21, 2017, 09:53:15 PM »
I am changing from carb. set up to Enderle injection. I am basically removing the carb. set -up and just installing the Enderle/ tunnel ram set up. I am installing a primer to have that ability to start engine easy.
Selling my cooling system to. I would not worry about your motor,if built well.
Selling my cooling system to. I would not worry about your motor,if built well.
14
Front Engine Dragsters / Re: What did you do on your Front Engine Dragster TODAY?
« on: April 11, 2017, 04:48:07 PM »
Well,started piecing together my Enderle injection system. This is a whole new ballgame for me and should be interesting. I am going to send it out and have it set up.
