1
Wanted to sell / Re: 192" Front engine dragster
« on: September 07, 2017, 06:20:32 PM »
SOLD SOLD SOLD
FEDs Forever!
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Wanted to sell / Re: 192" Front engine dragster
« on: August 18, 2017, 08:53:20 PM »
It's 18" inside to inside of the second hoop to the padding...Probably 19" to the bar.
And it's 33" from the back of the motor plate to the center of the rear axle.
Shane
And it's 33" from the back of the motor plate to the center of the rear axle.
Shane
3
Wanted to sell / 192" Front engine dragster
« on: August 16, 2017, 02:54:56 PM »
*1960's Dragster
*Front half of frame is SPE
*Jerry Hill back half and body
*192" wheel base
*331 ci small block Chevy
*Concreted 350 4 bolt block
*Steel big journal 327 crank
*Hilborn alcohol injected
*Brodex aluminium heads
*BME aluminium rods
*2 speed glide with brake
*Olds rear with 4.30 gears
*Runs 9.0's @150mph
*Fits 5-10" 200lbs(ish) driver.
*20 layer fire suit.
*Will need cert & updates to run
There's just WAY to much to list here...
20k cdn
16k usd
Shane
Home 604-853-6900
Cell 778-808-2816
*Front half of frame is SPE
*Jerry Hill back half and body
*192" wheel base
*331 ci small block Chevy
*Concreted 350 4 bolt block
*Steel big journal 327 crank
*Hilborn alcohol injected
*Brodex aluminium heads
*BME aluminium rods
*2 speed glide with brake
*Olds rear with 4.30 gears
*Runs 9.0's @150mph
*Fits 5-10" 200lbs(ish) driver.
*20 layer fire suit.
*Will need cert & updates to run
There's just WAY to much to list here...
20k cdn
16k usd
Shane
Home 604-853-6900
Cell 778-808-2816
Pages: [1]