FrontEngineDragsters.Org Forum
Drag Racing Discussions => Altereds => Topic started by: Dunc the Funk on November 11, 2021, 10:11:50 AM
-
Since we removed the coilovers from the rear of our car & made it solid, it launches FAR better. However it is now prone to bouncing in the shutdown area or if the driver has to get off the throttle in a hurry without pulling the chute first.
The wheelbase is 113". I'm thinking there are two ways to go which might improve the situation:
1. Extend the wheelbase to 125" & replace the beam axle with the modern triangulated axle mount system.
2. Keep the wheelbase short but add front suspension (most work I guess).
Any opinions on what would be best?
-
In my limited experience, a solid suspension car will bounce, period. Flexie flyier top fuel cars are worse yet (ie, longer wheelbase). Adding suspension is most likely your only option to correct it. And, you may never completely fix the issue. Look at your rear tires. That big soft sidewall will add suspension, but also make the car bounce.
-
Fact above, they bounce. I have had my 150" FED all four up in the air in the shutdown on a bad track. My spine says thank you. Pull the chute first, then "slowly and steady" release the loud pedal helps.
-
Thanks for opinons, I thought that might be the case. We really don't want to go back to rear suspension as the launch was unpredictable. We'll just have to be careful I guess.
-
I believe a hard tail is going to have a bouncing problem and longer more flexible the chassis the worse it will be. Adding front suspension may help a little but most of the problem is from the rear of the car. They typically have 65% or so of the weight on the rear and the rear tires are much larger which can act like a basketball. I would really want to know why it did not work well suspended. I would make sure it has a good anti-roll bar, take the shocks off and work it through entire range and make sure no binding or slack. Then I would want to put a GoPro camera on the rear suspension and see what it is doing at the hit. If there is not a good stiff anti roll bar that is first thing I would add. If you have a good one then I would also try the tests for binding and slop with and with out the anti-roll bar.
Rear tire pressure. The higher the pressure the more it will bounce. Too low and it will wallow around and feel mushy down track. On my 225" Front Engine Dragster there is very little between the two. A suspended car has so much more room for error and a shorter stiffer chassis needs the suspension in my opinion. With that said many argue that once you get to a certain ET then a suspended car will not work. I am not sure I believe that. I was told faster than 4.70 in the 1/8 mile you need a hard tail.
-
I believe a hard tail is going to have a bouncing problem and longer more flexible the chassis the worse it will be. Adding front suspension may help a little but most of the problem is from the rear of the car. They typically have 65% or so of the weight on the rear and the rear tires are much larger which can act like a basketball. I would really want to know why it did not work well suspended. I would make sure it has a good anti-roll bar, take the shocks off and work it through entire range and make sure no binding or slack. Then I would want to put a GoPro camera on the rear suspension and see what it is doing at the hit. If there is not a good stiff anti roll bar that is first thing I would add. If you have a good one then I would also try the tests for binding and slop with and with out the anti-roll bar.
Rear tire pressure. The higher the pressure the more it will bounce. Too low and it will wallow around and feel mushy down track. On my 225" Front Engine Dragster there is very little between the two. A suspended car has so much more room for error and a shorter stiffer chassis needs the suspension in my opinion. With that said many argue that once you get to a certain ET then a suspended car will not work. I am not sure I believe that. I was told faster than 4.70 in the 1/8 mile you need a hard tail.
^^^ X2
Re suspension on faster cars: I don't buy that it won't work. Don't Pro Mods and Pro Stocks and FAST Comp Eliminator altereds have suspensions? Surely then, one can be made to work on a fast altered.
-
On the 160" fed we had bad bounce, even ran off the end of an outlaw track with short shut down area, the remedy for us was to shift into neutral before braking.
-
On the 160" fed we had bad bounce, even ran off the end of an outlaw track with short shut down area, the remedy for us was to shift into neutral before braking.
Using the parachute helps with bouncing in the shut down. Still if you have suspension I would try to make it work.
-
How much air pressure in rear tires?
With my FED, once I got under 5#s I could do what ever I wanted with the brakes and it wouldn't bounce.
Once you get rid of the shocks your tires became your suspension.
-
Interesting! We have had no traction problems at the very well prepped Santa Pod track this year so we had them up at 6 & even 6.5psi. We had our first bad bounce there when the driver started braking before the chute hit (not normal!).
When we went to the Melbourne (Yorkshire) 1/8 mile no prep track I would have dropped them to 5. However the driver seemed to think it would be more controllable keeping them at 6.
-
Cariotta Banick from Ogden was on the hunt for types of thesis study
Mildred Velo stumbled upon the resolution to a research question types of thesis study
investigating the young modulus of a wire coursework
faculty of biology cambridge dissertation guidelines
dissertation printing madison wi
thesis salut administration
<a href="https://ouressays.com/">writing services</a>
<a href="https://topswritingservices.com/">essay writing services</a>
<a href="https://payforanessaysonline.com/">thesis paper</a>
are good essay writing service (https://ragnarok.ch/forum/viewthread.php?thread_id=47314&pid=222534#post_222534) 197e692