FrontEngineDragsters.Org Forum

Technical => Dan Dishon's Transmission Den => Topic started by: JeffV8 on August 09, 2015, 12:57:07 PM

Title: Doug Nash 3+1 trans
Post by: JeffV8 on August 09, 2015, 12:57:07 PM

I just bought a Doug Nash 4+1 tranny. Would anyone know what bolt pattern they use to bot to scatter shield??  It will be shipped to me on Monday.

Title: Re: Doug Nash 3+1 trans
Post by: bikeguy307 on August 10, 2015, 05:10:02 AM

Well this is something that is out of my wheel house, hopefully some of our members will know the answer. I will do some digging in the mean time.

Dan

Title: Re: Doug Nash 3+1 trans
Post by: dreracecar on August 10, 2015, 08:04:05 AM

Call someone that makes SFI belhousings (Mcleod, lakewood, Browel, etc)

Title: Re: Doug Nash 3+1 trans
Post by: JeffV8 on August 10, 2015, 11:00:45 AM

I will do that Bruce 👍👍👍👍👍

Title: Re: Doug Nash 3+1 trans
Post by: MikenMpls on August 10, 2015, 05:13:09 PM

I had one in my '67 camaro (502 and lakewood can). The scattershield had the bolt pattern already there. The trans bolted right up but getting the throw out brng right was a bit of a pain with the centerforce clutch. Needed a long(tall) brng to reach the fingers of the pressure plate.  The pattern may have been toploader (Ford) but I don't recall.