FrontEngineDragsters.Org Forum

Drag Racing Discussions => Front Engine Dragsters => Topic started by: Racing6 on February 24, 2015, 06:35:57 AM

Title: Front Spindles
Post by: Racing6 on February 24, 2015, 06:35:57 AM
My car has home made spindles and I need front wheels. I have found some spindles but don't know how to ID them I can stay with original or use new, just don't what I have   
Title: Re: Front Spindles
Post by: dreracecar on February 24, 2015, 07:58:57 AM
Hold them up to the computer screen so that someone might be able to ID them.

Seriously---If you want something ID'd   YOU HAVE TO POST PICTURES!!!!!
Title: Re: Front Spindles
Post by: JrFuel Hayden on February 24, 2015, 09:33:30 AM
Also measure the spindle length, &  inner [ closest to the king pin] bearing area OD and outer [ cotter-pin/ nut] bearing OD, and post them or Email me jchansen60@gmail.com,  I no doubt will have wheels for you, or can make something.

Jon Hansen, Hayden Wheels, 800-624-3803
Title: Re: Front Spindles
Post by: Racing6 on February 24, 2015, 04:04:06 PM
Sorry about Pictures, I was asking how to ID them  But good point will get instruction from my grandkid tonight on how to up load a picture and post it tomorrow. Jon shaft length is 3.46 inch, Large bearing is .99 inch,small bearing .626 These are from spindle I found. Will get measurements of original tonight Thanks will e-mail you to get prices of wheels
Title: Re: Front Spindles
Post by: dreracecar on February 24, 2015, 04:17:56 PM
Inner should be 25mm and the outer .625 for it to be considered an Anglia type. Very common, and still quite prevalent today.  kingpin dia shoud be close to 11/16
Title: Re: Front Spindles
Post by: Racing6 on February 25, 2015, 05:42:04 AM
Thank You those are the sizes
Title: Re: Front Spindles
Post by: JrFuel Hayden on February 25, 2015, 12:06:23 PM
Yes, Bruce is right you have Anglia type spindles,
let me know if you want wheels, if cost is an issue, call me I have some trade-ins/ close-outs for sale.

Jon, Haydenent.com, 805-444-4489