Technical > Spud Miller's Cave

hilborn pump

(1/2) > >>

hotrod316:
help please!
Hilborn pump ?
numbers one the pump
1-2067
pg-1  08
thanks Steve m. 8)

Pipe Dreams:
Have a couple old hilborn pumps spud just freshened. 1 is like a dash 1 enderle pump. Both of my pumps are number 1's and flow 6.42 and 6.67 gpm respectively. The second numbers are just the serial number.

Spud Miller:

--- Quote from: hotrod316 on May 21, 2014, 12:28:47 PM ---help please!
Hilborn pump ?
numbers one the pump
1-2067
pg-1  08
thanks Steve m. 8)

--- End quote ---

Yup, it's a -1 so it should make more than 6 GPM if it's healthy. The "PG" is definitely a Hilborn thing. Generally, it should say 150A, 150C, 175 or something like that after the PG. Maybe someone ground it off or something?

 Spud

hotrod316:
thanks x2
steve m

hotrod316:
ok gang, trying to figure out the plumbing on this pump, read somewhere hilborn no longer recomends using certain ports on their pumps.  this is the same pump as before, thinking its a pg-150b with the center 5 ground down to a single point, can read pg-1.0B so we will say it is.

have  blocked off the "relief" port and wanting to use the "bypass" fir our main idle circuit. would be alright in your book spud...
here is some pic glory saorry for so small couldnt get below the 150kb index (tryed putting boost and nitro to it) :o

thanks matt

PS- just any new radiator hose for an import for my 1" fuel hose to connect my tank will be methanol and nitro safe right? just wanted to be sure, thanx again

Navigation

[0] Message Index

[#] Next page