« previous next »
Pages: [1]   Go Down

Author Topic: Header Question  (Read 4312 times)

Offline Oldschool

  • Full Member
  • ***
  • Posts: 122
    • View Profile
  • Your Best Time: 8.42 in a BB Chevy Altered 9.28 in my Vega
  • Your Engine: 434 Scott Shafiroff Racing Engine
  • Your Track: US 36 , Mo Kan and Heartland Park Topeka
  • Your Vehicle: 173" Front Engine Dragster
Header Question
« on: May 05, 2014, 04:07:54 PM »
 I have Brodix cnc 227 SBC heads with standard exhaust bolt pattern. The car I bought has zoomie headers with spread port pattern. I was told by a major header manufacturer that they can make adapter from a 6 bolt to a 7 bolt,but the center ports will not match up right.
Can someone chime in ?
I guess if I can not use will have to sell these and buy a set with standard.
Logged
It is not the years in your life
But the life in your years

dreracecar

  • Guest
Re: Header Question
« Reply #1 on: May 05, 2014, 05:55:02 PM »
It will work just fine with the adapters.  Get a gasket and lay it over the ports.  Built many a system like that on cars that run 7.0
Logged

Offline Oldschool

  • Full Member
  • ***
  • Posts: 122
    • View Profile
  • Your Best Time: 8.42 in a BB Chevy Altered 9.28 in my Vega
  • Your Engine: 434 Scott Shafiroff Racing Engine
  • Your Track: US 36 , Mo Kan and Heartland Park Topeka
  • Your Vehicle: 173" Front Engine Dragster
Re: Header Question
« Reply #2 on: May 07, 2014, 12:40:26 PM »
Really appreciate the info. you sent.
Logged
It is not the years in your life
But the life in your years

Offline gregm784

  • Sr. Member
  • ****
  • Posts: 384
    • View Profile
    • Means Racing
  • Your Engine: 365" GenIV SBC
  • Your Track: Famoso Raceway
  • Your Vehicle: 1997 Stirling 200" FED
Re: Header Question
« Reply #3 on: June 02, 2014, 03:48:56 PM »
Bought my adapters from:

http://www.nimac.biz/5.htm

Nice quality
Logged
Greg
El Dorado County, CA
www.meansracing.com
Pages: [1]   Go Up
« previous next »