Technical > Roo Man's Room

Coupler Cover ?

<< < (5/5)

dreracecar:
You can telescope the 2 pieces or you can split the tube and have marmon band clamps on each end as long as the split tube goes around somthing on each end and one clamp in the middle. just make sure you cut any excess thread past the nut to keep from getting hung up.

PSweeney:

--- Quote from: wideopen231 on March 12, 2014, 02:02:37 PM ---Question on this subject since its one thing I still have not made up. Since mines soild shaft with couplers and I will need quick access will two piece tube in slip fashion work? One fastened to the rear ,other sliding over it to trans with some sort of locking divice in middle on top,still working on that part. Mines is also about 12" from trans to rear coupler

--- End quote ---

on the first version of my set up, I split a piece of 4" tube and welded tabs to bolt the two halves together, the principle being I can push the yoke back into the box and lift the motor/ trans out vertically once the steering gear is swung out the way. 

Navigation

[0] Message Index

[*] Previous page