Drag Racing Discussions > Front Engine Dragsters

Trans blanket

<< < (4/4)

ss4:
thanks for the thought on tilting.  I will give that a look.  I am going to get a tci shield to compare fit with the blanket and get that knocked out over the weekend.  thanks

ss4:
so I picked up a new TCI shield.  looks nice all red and such.  I have the shield bolted to the trans at the servo.  out of  the box only one of the 3 brackets fit with out rebending.  As for the pan bracket it is a no way with out adding and subtracting material.   First issue is the second set of holes for a deep pan are not "long" enough to fit my TCI deep pan (go figure), second it has a hard interference with the shift cable bracket (also TCI).  Sure seems they would have installed at least one of these things as a completed trans and not just a component by component basis.  Any rate question is can I modify the pan bracket, I know I can not touch the top piece with the expense sticker.

dreracecar:
Call TCI and ask about the lower strap and complain about the cable problem

ss4:
according to TCI "modify the bottom loop to fit the application"

bigaxel:
Look at the CSR trans shields. I've used them in tight fit applications with great success. they can be re-certified as well.

Navigation

[0] Message Index

[*] Previous page