Drag Racing Discussions > Front Engine Dragsters
Trans blanket
ss4:
were you able to maintain the same shaft exit out the side panel?
rooman:
--- Quote from: ss4 on March 05, 2014, 10:26:32 AM ---were you able to maintain the same shaft exit out the side panel?
--- End quote ---
Just tilt the box a little so that you don't have to mess with the bodywork. A lot of the period cars had the box tilted so that the shaft exited low--it made it easier to get the drag link under the headers--especially with a hemi.
Roo
dreracecar:
--- Quote from: rooman on March 05, 2014, 04:05:16 PM ---
--- Quote from: ss4 on March 05, 2014, 10:26:32 AM ---were you able to maintain the same shaft exit out the side panel?
--- End quote ---
Just tilt the box a little so that you don't have to mess with the bodywork.
--- End quote ---
Cardboard is cheap ;D
BK:
I would just put a bag on it. I had similar issues only it was the accelerator pedal that got in the way. I went with a bag, went a lot of rounds with no issues. Granted it's not ideal but it will work fine. And if you manage to break the case with the planetary you will probably wear less oil.
ss4:
--- Quote from: dreracecar on March 05, 2014, 07:27:25 PM ---
--- Quote from: rooman on March 05, 2014, 04:05:16 PM ---
--- Quote from: ss4 on March 05, 2014, 10:26:32 AM ---were you able to maintain the same shaft exit out the side panel?
--- End quote ---
Just tilt the box a little so that you don't have to mess with the bodywork.
--- End quote ---
Cardboard is cheap ;D
--- End quote ---
LOL guess you are right on the cardboard.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version