Drag Racing Discussions > Front Engine Dragsters
Rules on the seat pan in an FED?
dwrfab:
Get a kit and do a pour in seat that will expand to fit your back and sides.
up in smoke:
i am getting it out of the trailer this week , i will take some pics, we used cabinet door hinges so the hood would clear the motor plate when raised, slightly shifting up as well as forward so it wont pinch.we use two bungy straps with the balls on them and just loop them around a pin on each side. by doing it this way we built the steering shaft structure to make handles topull you out as well to aid in getting in...not to mention that when i need to work on anything from the motor plate back, all i have to do is raise the hood
dusterdave173:
I have a seat kit for sale--bought WAY too big a pour kit--have more than half left for a deal--call me 794 244 6649 It was the best $$ I spent on my entire car far as comfort and safety--
rooman:
--- Quote from: dusterdave173 on January 24, 2015, 01:02:22 PM ---I have a seat kit for sale--bought WAY too big a pour kit--have more than half left for a deal--call me 794 244 6649 It was the best $$ I spent on my entire car far as comfort and safety--
--- End quote ---
Good move Dave. As you obviously found out, the Cen-Pen car really does need a seat pour package to support your lower back due to the seat/rear end configuration.
Roo
George:
--- Quote from: dusterdave173 on January 24, 2015, 01:02:22 PM ---I have a seat kit for sale--bought WAY too big a pour kit--have more than half left for a deal--call me 794 244 6649 It was the best $$ I spent on my entire car far as comfort and safety--
--- End quote ---
PM me with the info and price on the left over seat kit please. Thanks. George
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version