Technical > Roo Man's Room
wheelie bars
wideopen231:
Yea it would be nice if everytime we needed more racing money we could take it from everyone in america rather they liked it or not.
masracingtd1167:
Last time that I checked titanium tubing was about 34 dollars a foot ! A little too expensive for me !
wideopen231:
Was at local chassis builders today had set sitting there out of titainium and told me it was 42 per foot so my thre bar set 6' long would b3e about 800 bucks just for tubing.
rooman:
When I was running the fab shop at JFR we were paying $2 per inch for 3/4" x .060 on the secondary market.
Roo
wideopen231:
If jr fuel I guess I could see it.Small motor needs all the weight savings you can get.I still would not spend the money until I had done everything else to cut weight and make every ponie I could then I would go to what I call this extreme.
Any one know what weight savings would be for say single wheel 3 bar 6' long wheelie bar?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version