Technical > Matt Shaff's Engine Shop

Oil tank

<< < (6/8) > >>

hotrod316:
 just be carefull when you weld something new or repairing the tubing it can fun ???
 the valve cover can go flying ;)
but I been wrong wants I think 8)

ss4:

--- Quote from: dreracecar on January 13, 2014, 10:26:46 AM ---
3 psi is not enough try 17psi and plumb into headers, make sure to drill 1/8" drain holes in each tube at the lowest point.

--- End quote ---

Are you saying to run the water to one of the zoo is tubes? 

dreracecar:
Check valve in expantion tank, -4 stainless line into #1 header. Exhaust blows any water away from the rear tire

ricardo1967:
I'm lost... got totally confused past the point where it's mentioned plumbing cooling (water) and engine breather to the same tank... please help!

ss4:
just trying to streamline a little and not have 2 tanks.  If the both are waste then why not send to the same tank.  I am not  running a radiator so the amount of water ending up in the tank will be a mere spit.

Navigation

[0] Message Index

[#] Next page

[*] Previous page