Author Topic: GY 2070 and 2078  (Read 7433 times)

Offline wideopen231

  • Hero Member
  • *****
  • Posts: 1911
    • View Profile
  • Your Best Time: 1/8 3.70@ 198 1/4 5.78@245
  • Your Engine: Hemi 526 ci alcohol
  • Your Track: Piedmont
  • Your Vehicle: 225 CMC FED
  • General Location: NORTH CAROLINA
GY 2070 and 2078
« on: May 29, 2022, 12:54:05 PM »
Looking at new slick options. In GY selection two look like possibilities.  2070 and 2078. Wondering if any here have tried either/or results and thoughts on them.

Use to be you could try a cpl different setups,sale off later and lose a little with cost increase you need second mortage to buy 2 or 3 sets of tires
Relecting obama is like shooting right foot because it did not hurt enough when you shot left foot

Offline Paul New

  • Hero Member
  • *****
  • Posts: 744
    • View Profile
  • Your Best Time: 6.47 @ 214 MPH SBC
  • Your Engine: 387" SBC
  • Your Track: Woodburn Dragstrip
  • Your Vehicle: 2005 FED
Re: GY 2070 and 2078
« Reply #1 on: June 04, 2022, 08:06:19 AM »
I ran the D2070’s on my car for years had shake issues and when it did t shake my car would walk down the track not really that straight.  Last year I switched to the 13.00 33.3 -16 M&H tires which are currently impossible to get. What I can tell you is with these stiffer side wall tires my car runs perfectly straight down the track.  I recommend a finding a stiffer side wall tire then the D2070’s.  My car runs 6.47-6.70 SBC with a 10” 2 disk and B&J 3 spd.  I run with another FED powerglide car he has the MT big bubbas which I think are ugly on a FED (my opinion doesn’t matter) but it works great for him 6.90-7.0’s no shake

Offline wideopen231

  • Hero Member
  • *****
  • Posts: 1911
    • View Profile
  • Your Best Time: 1/8 3.70@ 198 1/4 5.78@245
  • Your Engine: Hemi 526 ci alcohol
  • Your Track: Piedmont
  • Your Vehicle: 225 CMC FED
  • General Location: NORTH CAROLINA
Re: GY 2070 and 2078
« Reply #2 on: November 10, 2022, 08:26:07 AM »
The big bubbas are very popular with RED guys,not sure I have enough power to pull that tire on FED. I know FED's normally get down track better with less tire than a rqual power RED needs. Being a bracket car I have to be more concerned about consistency than fast. As life long tuner of heads up not putting fast first and foremost is hard as xxxx.
Relecting obama is like shooting right foot because it did not hurt enough when you shot left foot

Offline tcoupekyle

  • Sr. Member
  • ****
  • Posts: 354
    • View Profile
  • Your Best Time: 4.70 1/8
  • Your Track: Houston Motorsport park
  • Your Vehicle: 225" slip joint FED
  • General Location: Houston
Re: GY 2070 and 2078
« Reply #3 on: November 10, 2022, 10:56:48 AM »
33x17x15 Mickey Thomson On my fed and it shook like crazy with 1000hp.

Changed to 33x10.5x15 and haven’t tried yet

Offline slingshot383

  • Full Member
  • ***
  • Posts: 143
    • View Profile
  • Your Best Time: 1/4 mi. 7.95 @ 168
  • Your Engine: Chrysler, alcohol, 528 cu.in.
  • Your Track: Gateway Motorsports Park (the Swamp)
  • Your Vehicle: Undercover Chassis 23T altered
Re: GY 2070 and 2078
« Reply #4 on: March 01, 2023, 03:40:04 PM »
I've seen a lot of people have good luck with the 10.5 or 10.5W slicks on their FED's.
Undercover 23T Altered, big block Mopar
Member of the Torque and Recoil Club

Offline JEFF/21C

  • Full Member
  • ***
  • Posts: 122
    • View Profile
  • Your Best Time: N/A
  • Your Engine: 306 SBC INJECTED ALKY
  • Your Track: NONE
  • Your Vehicle: 23 T ALTERED
  • General Location: eastern canada
Re: GY 2070 and 2078
« Reply #5 on: March 01, 2023, 04:30:29 PM »
 We ran 10wx33 hoosier on 12" rims  it worked rather well on all surfaces