Author Topic: Aluminum rods and nitro  (Read 5706 times)

Offline msundstrom

  • Full Member
  • ***
  • Posts: 119
    • View Profile
  • Your Best Time: 7.45 @ 182 in 1/4
  • Your Engine: NA Injected 505 BBC on 45%
  • Your Track: Woodburn Dragstrip
  • Your Vehicle: FED
  • General Location: Washington Coast
Aluminum rods and nitro
« on: October 22, 2013, 03:54:33 PM »
Spud'
At what % should I be considering aluminum rods?
Thanks
Mark S

Offline Spud Miller

  • Global Moderator
  • Sr. Member
  • *****
  • Posts: 332
    • View Profile
    • Fuel Injection Ent., LLC
Re: Aluminum rods and nitro
« Reply #1 on: October 22, 2013, 05:29:00 PM »
I would say at 50% or higher they are a must. Quite a few customers are running steel H beam rods with 30% just fine.


Fuel Injection Enterprises, LLC
     Mechanical Injection
     Magnetos
     EFI Conversions

Offline msundstrom

  • Full Member
  • ***
  • Posts: 119
    • View Profile
  • Your Best Time: 7.45 @ 182 in 1/4
  • Your Engine: NA Injected 505 BBC on 45%
  • Your Track: Woodburn Dragstrip
  • Your Vehicle: FED
  • General Location: Washington Coast
Re: Aluminum rods and nitro
« Reply #2 on: October 22, 2013, 09:11:05 PM »
Thanks

Offline hotrod316

  • Sr. Member
  • ****
  • Posts: 352
    • View Profile
Re: Aluminum rods and nitro
« Reply #3 on: October 23, 2013, 05:45:22 AM »
why? thanks
steve m.

Offline Spud Miller

  • Global Moderator
  • Sr. Member
  • *****
  • Posts: 332
    • View Profile
    • Fuel Injection Ent., LLC
Re: Aluminum rods and nitro
« Reply #4 on: October 23, 2013, 09:00:11 AM »
 Steel rods transfer every bit of the impact and shock loading into the bearings and crank. The shock loads are much greater running nitro and aluminum rods are generally accepted as helping to cushion this somewhat.

Fuel Injection Enterprises, LLC
     Mechanical Injection
     Magnetos
     EFI Conversions

Offline hotrod316

  • Sr. Member
  • ****
  • Posts: 352
    • View Profile
Re: Aluminum rods and nitro
« Reply #5 on: October 24, 2013, 06:11:41 AM »
thanks ! I have lots more thoughts  :o again, thanks for your time