« previous next »
Pages: [1]   Go Down

Author Topic: slicks  (Read 13747 times)

Offline Kris b.

  • Newbie
  • *
  • Posts: 6
    • View Profile
  • Your Best Time: 5.58 & 8.76
  • Your Track: Eastside speedway
  • Your Vehicle: f.e.d.
slicks
« on: October 18, 2013, 08:09:03 PM »
Hoosiers, what compound are you using? Getting ready to buy a set for next season gets here
Logged

Offline masracingtd1167

  • Hero Member
  • *****
  • Posts: 1110
  • bill masiello Shelton Ct.
    • View Profile
  • Your Best Time: 7.40's at 181 on motor 6.94 at 192 nitrous
  • Your Engine: 394 chevy
  • Your Track: Lebanon Valley Dragway
  • Your Vehicle: 2003 Neil and Parks
Re: slicks
« Reply #1 on: October 19, 2013, 09:21:25 AM »
Kris b I am using the 12x33 Hoosiers Part no 18350  compound is co9 .
Logged

Offline proriv63

  • Newbie
  • *
  • Posts: 34
    • View Profile
  • Your Best Time: TBD
  • Your Engine: Chevy, Gas, 422"
  • Your Track: Maple Grove
  • Your Vehicle: 205" Ken Keir
Re: slicks
« Reply #2 on: October 19, 2013, 04:50:03 PM »
Hi, do run them tubeless?  what rear gear are you running?

thanks,
john
Logged

Offline Kris b.

  • Newbie
  • *
  • Posts: 6
    • View Profile
  • Your Best Time: 5.58 & 8.76
  • Your Track: Eastside speedway
  • Your Vehicle: f.e.d.
Re: slicks
« Reply #3 on: October 19, 2013, 05:33:47 PM »
Do you have you're rubber on a 10 or 12" rim? Im currently running a 31x 10.a mt m5 compound gotta leave line at 3500. Any higher then that it'll knock the tires off. 60' is a  1.34 at best. Im running these tires on a 10" rim.
Logged

Offline msundstrom

  • Full Member
  • ***
  • Posts: 119
    • View Profile
  • Your Best Time: 7.45 @ 182 in 1/4
  • Your Engine: NA Injected 505 BBC on 45%
  • Your Track: Woodburn Dragstrip
  • Your Vehicle: FED
  • General Location: Washington Coast
Re: slicks
« Reply #4 on: October 19, 2013, 06:18:05 PM »
I'm running the same Hoosier on a 10" wheel/Injected BBC, 3.89 gears and leave at 5,000. 60' is 1.19-1.2
Mark
Logged

Offline proriv63

  • Newbie
  • *
  • Posts: 34
    • View Profile
  • Your Best Time: TBD
  • Your Engine: Chevy, Gas, 422"
  • Your Track: Maple Grove
  • Your Vehicle: 205" Ken Keir
Re: slicks
« Reply #5 on: October 20, 2013, 05:47:12 AM »
Mark,
Are you running the Hoosier's tubeless?

Thx,
John
Logged

Offline masracingtd1167

  • Hero Member
  • *****
  • Posts: 1110
  • bill masiello Shelton Ct.
    • View Profile
  • Your Best Time: 7.40's at 181 on motor 6.94 at 192 nitrous
  • Your Engine: 394 chevy
  • Your Track: Lebanon Valley Dragway
  • Your Vehicle: 2003 Neil and Parks
Re: slicks
« Reply #6 on: October 20, 2013, 06:04:44 AM »
Quote from: proriv63 on October 19, 2013, 04:50:03 PM
Hi, do run them tubeless?  what rear gear are you running?

thanks,
john
Yes I run them tubeless and I run  a 4.56 gear . I only have 6 runs on that tire and it seem's a little different than the goodyear . The hoosier wants more air like 7lbs compared to the Goodyear 6lbs but overall I think it is a good tire .
Logged

Offline George

  • Hero Member
  • *****
  • Posts: 515
    • View Profile
  • Your Vehicle: 1964 Mercury Comet Super Stock/ M automatic
  • General Location: Midwest USA
Re: slicks
« Reply #7 on: October 20, 2013, 06:27:49 AM »
I have tried 3 different 12" Hoosier tires with 4.30 and 4.88 gears on our FED. So far the Goodyear 2585 has proven to be the fastest tire we have run.
Logged

Offline proriv63

  • Newbie
  • *
  • Posts: 34
    • View Profile
  • Your Best Time: TBD
  • Your Engine: Chevy, Gas, 422"
  • Your Track: Maple Grove
  • Your Vehicle: 205" Ken Keir
Re: slicks
« Reply #8 on: October 20, 2013, 07:32:56 AM »
The Goodyear D2585 is not available, right?
Logged

Offline msundstrom

  • Full Member
  • ***
  • Posts: 119
    • View Profile
  • Your Best Time: 7.45 @ 182 in 1/4
  • Your Engine: NA Injected 505 BBC on 45%
  • Your Track: Woodburn Dragstrip
  • Your Vehicle: FED
  • General Location: Washington Coast
Re: slicks
« Reply #9 on: October 20, 2013, 08:26:53 AM »
I run mine tubeless.
Mark
Logged

Offline Cajuninjector

  • Jr. Member
  • **
  • Posts: 64
    • View Profile
  • Your Best Time: 7.50@176
  • Your Engine: SBC 406 Alky Stacked Hilborn
  • Your Track: SWJFA
  • Your Vehicle: 225" FED-Wizard Race Cars
Re: slicks
« Reply #10 on: October 20, 2013, 11:12:01 AM »
I got 2 sets of 2585's from "Carter-Maxwell Goodyear" in Oklahoma about a month ago. They MAY have  a set but would look into it ASAP.
That is the only tire I like to run because of the weight. I have a set of Goodyear 33x12.5 that are 8 pounds heavier than the 31x12 Goodyear 2585....and that's per tire
I run a 4.30 rear gear and a 1.69 1st gear. 
Leave the tubes for the bikes.
Also, the 2585's are notorious for slowly leaking air so rub dawn dishwashing liquid on the inside of the tire before you mount them to keep it from leaking air.
Logged
Go Hard or Go Home

Offline proriv63

  • Newbie
  • *
  • Posts: 34
    • View Profile
  • Your Best Time: TBD
  • Your Engine: Chevy, Gas, 422"
  • Your Track: Maple Grove
  • Your Vehicle: 205" Ken Keir
Re: slicks
« Reply #11 on: October 22, 2013, 07:45:39 AM »
From an un-proven combination perspective it doesn't make sense to acquire the Goodyear D2585 slicks because eventually they will be non-existent.  You're only buying yourself a year or so.  Might as well go to the Hoosier or M/T now and bite the R&D Tuning bullet now, right?

thanks,
John
Logged

Offline JrFuel Hayden

  • Hero Member
  • *****
  • Posts: 600
    • View Profile
    • Hayden Enterprises Speciality Wheels
  • Your Best Time: 6.02, 236 mph, 1/4 in 1973 Div 3 TF Champ
  • Your Engine: SBC, Alky, 403 ci, Best 6.99 @ 190 & 409 Hemi
  • Your Track: Bakersfield
  • Your Vehicle: 225" FED NHRA Heritage Jr Fuel
Re: slicks
« Reply #12 on: October 28, 2013, 02:15:25 PM »
I have some NEW GoodYear D2585, 31x12x15 tires. When I found out the D2585's were not going to be on a production schedule for 2012 and 2013, I pre-sold 180 tires and GoodYear made another batch for us.

Call me, 805-444-4489 [ Calif] if you'd like the light weight, 22.6 lbs, tires. All other choices weigh 8 lbs more per tire. The D2585 is what is very successful on JrFuel FED's.

Jon, Hayden Wheels
Logged
Jon C. Hansen

Hayden Wheels

Offline proriv63

  • Newbie
  • *
  • Posts: 34
    • View Profile
  • Your Best Time: TBD
  • Your Engine: Chevy, Gas, 422"
  • Your Track: Maple Grove
  • Your Vehicle: 205" Ken Keir
Re: slicks
« Reply #13 on: October 29, 2013, 03:54:02 AM »
Hi Jon,
Thanks for taking the time to respond to my question.  I will have my chassis builder give you a call to discuss the slicks, we will also need front tires and spoke wheels, as we are just starting a new chassis build.

Thanks,
John
Logged
Pages: [1]   Go Up
« previous next »