Drag Racing Discussions > Front Engine Dragsters
What did you do on your Front Engine Dragster TODAY?
Supercat:
No other issues in the trans were found other than the Teflon seals were weak...
Different seals are now installed. I pick up the trans tomorrow at some point.
The converter is getting looked at this week and cut open to adjust a bit and see what things look like on the inside.
The new fuel engine is getting closer also ;D...........Should be here in December
As for today I did touch the car and worked on some changes to the trailer as it was cool today @ about 69-70 degrees ;)
FEDNV:
Not just today but after the HRR started tearing the dragster down as I had broke the spool and one thing led to another so now I am in the process of powder coating the chassis, repainting the body (new nose piece redo), new 3rd member and axles, complete rewiring, upholster the seat and misc changes/updates.
wideopen231:
what that big fat thing parked in garage next to your racecar? That stuff belongs out side not next to a racecar.
gasserx:
Just bought an engine to put into my FED :)
masracingtd1167:
Spent the last few days taking my motor apart to freshen it up . It has about 100 runs on it so I am going to put a set of rods in it ,rings and bearings . Every thing looks really good exept the coating on my piston skirts . I will send them out to be re coated . What's every one else up too ?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version