Drag Racing Discussions > Front Engine Dragsters
What did you do on your Front Engine Dragster TODAY?
Quartermiler:
Got the new main bearings installed and the Jesel belt drive on!
tylercrawford:
All kinds of little machining.
Made spud ends for my tie rod, or thread adapters/whatever. Had to machine a little spacer ring because the hub I got from good vibes has a 2" O.D. while this blower pulley I got off ebay has a 2.250" I.D.
Also, the QC on my enderle timing cover was a little sketchy. Had to enlarge the spot faces for the bolts and deburr the rear of the holes.
Pushrods come tomorrow. Dropping off my cylinder heads in the morning to get the valve seats/valve angles checked. Hope to have the entire longblock wrapped up this weekend.
Quartermiler:
New A-1 torque converter in, the engine is back in the frame! tomorrow babysit the grandaughter, Wednesday hope to get everything else hooked up!
afaulk:
Spent a few hours working on a customers RED, however I did bump my knee on the new tubing on the frame jig. New 200" car, frame is about 95%
buickfed:
other than snow, done nothing for over a week now. still trying to figure out how i can make everything fit on front with the 4-71/350 buick. darn w/p and alt is in the way of the belt.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version