Drag Racing Discussions > Front Engine Dragsters
What did you do on your Front Engine Dragster TODAY?
GlennLever:
--- Quote from: wideopen231 on April 30, 2013, 06:21:28 AM ---Finally got to where I could check the slipjoint for amount of chassis arch.
with jack under engine
--- End quote ---
How about a close up of the joint itself?
afaulk:
:o Uh oh, what have I done.
afaulk:
Amazing....Woo Hoo. Newsflash!!! Analog guy posts digital picture. More news at nine.
GlennLever:
--- Quote from: afaulk on April 30, 2013, 05:17:58 PM ---Amazing....Woo Hoo. Newsflash!!! Analog guy posts digital picture. More news at nine.
--- End quote ---
No more excuses for not posting more.
afaulk:
I've always done this hotrod thing for the fun of it and some things sure haven't changed. Started the above "belly button engine" for the first time this morning and have been grinning so hard I've got a face cramp :D. 370 cu in, Milodon block, dart heads, 8.5- 1, with a BDS 8-71 and bugcatcher, 80A-1 pump on alky. Very simple mild setup with a flat tapped cam and MSD 7AL-2 ignition. Previously have run a mag but had to try this. At 10% over, it sounds like a giant killer. Swapped the pulleys to 10% under, re-fired and it still sounds good. Bad batteries in the timing light, duhhh, will fine tune tomorrow.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version