Classifieds (Please No Dealers) > Wanted to sell

blower drive parts

(1/1)

wideopen231:
Im selling some of my blower drive stuff since I have 3 or 4 of most of them. Ihave some couplers for drive,shafts for snouts,a snout few starter cages and cpl pulleys 24,26,40 probably faster driver than most here will use 40 to 60% od range stuff.Few mag. idler pulleys. Contact me as to what you need.

GlennLever:

--- Quote from: wideopen231 on July 14, 2013, 10:59:05 AM ---Im selling some of my blower drive stuff since I have 3 or 4 of most of them. Ihave some couplers for drive,shafts for snouts,a snout few starter cages and cpl pulleys 24,26,40 probably faster driver than most here will use 40 to 60% od range stuff.Few mag. idler pulleys. Contact me as to what you need.

--- End quote ---
24 tooth pulley?

wideopen231:
yea Glen 24 tooth for when you want to go fast and see how quick you can wear the teflon in blower.I think it was for 66% over. I think we  where in Nebraska at Corky's track middle of summer and crappy air.

GlennLever:
It fits over the snout?

wideopen231:
had to trim about .060 off snout. Ever see a PSI at 120% od looks like thimble and wagon wheel pulley's. Plus I like running smallest puleys to get od I wanted since smaller bottom and top that makes same blower speed as two larger ones means less rotating weight.

 Tip. If you drill or maching opening in each groove it will make slight power differance(dyno proven).Theory is getting air from under belt makes it get full contact ansd some how makes od more accurate. Not sure I buy reason I do know two fellas who tested and said 15 to 20 hp gain. Im keeping full set of pulleys because they are machined and most likely other would worry about holes,never had problem.

Navigation

[0] Message Index