« previous next »
Pages: [1]   Go Down

Author Topic: Harness mounting  (Read 4720 times)

Offline mfp-66

  • Newbie
  • *
  • Posts: 38
    • View Profile
  • Your Engine: stock 68 cadillac 472
Harness mounting
« on: June 18, 2013, 02:38:10 PM »
How have you mounted your lap harness belts. Where I want to weld the fastening plate to the chassis the webbing is almost vertical, but to get it more at 45deg it would mount almost the center of my back where the shoulder mounts are.
« Last Edit: June 18, 2013, 02:49:55 PM by mfp-66 »
Logged

Offline rooman

  • Hero Member
  • *****
  • Posts: 559
    • View Profile
  • Your Best Time: 6.200/222.05 (1/4 mile--NT/F)
Re: Harness mounting
« Reply #1 on: June 18, 2013, 07:07:41 PM »
I would try to put the tab behind the upright so that the belt has some angle in it. Does the belt mount with a clip on deal or does the tab simply have a hole? It is a little hard to determine from the photo.

Roo
Logged
Yeah, I am from the south--any further south and I would have been a bloody penguin.

Offline mfp-66

  • Newbie
  • *
  • Posts: 38
    • View Profile
  • Your Engine: stock 68 cadillac 472
Re: Harness mounting
« Reply #2 on: June 18, 2013, 09:58:26 PM »
The mount has an eye bolt and the belt has a clip
Logged

Offline gregm784

  • Sr. Member
  • ****
  • Posts: 384
    • View Profile
    • Means Racing
  • Your Engine: 365" GenIV SBC
  • Your Track: Famoso Raceway
  • Your Vehicle: 1997 Stirling 200" FED
Re: Harness mounting
« Reply #3 on: June 21, 2013, 09:21:37 PM »
I'd lose the clip.  Weld in a small bar at the angle you want, and wrap the belt around it then back to itself with the adjuster. 
Logged
Greg
El Dorado County, CA
www.meansracing.com
Pages: [1]   Go Up
« previous next »