« previous next »
Pages: [1]   Go Down

Author Topic: protecting tubing during build  (Read 4963 times)

Offline wideopen231

  • Hero Member
  • *****
  • Posts: 1911
    • View Profile
  • Your Best Time: 1/8 3.70@ 198 1/4 5.78@245
  • Your Engine: Hemi 526 ci alcohol
  • Your Track: Piedmont
  • Your Vehicle: 225 CMC FED
  • General Location: NORTH CAROLINA
protecting tubing during build
« on: May 22, 2013, 05:25:54 PM »
While probably not a problem for Roo man,doubt he take 2 years to finish chassis. I need to put something on tubing to protect it during build.I can rub down with wd-40 or marvel mystery oil.I need somethine super easy to clean away for welding. Plus needs to be easy enough to wipe off before painting.  Any better ideas.
Logged
Relecting obama is like shooting right foot because it did not hurt enough when you shot left foot

Offline GlennLever

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 2010
    • View Profile
    • The Lever Family Site
  • Your Best Time: 1/4 mile 7.950 at 165 MPH
  • Your Engine: Pontiac 461 Alky Blown
  • Your Track: Empire Dragway, NY
  • Your Vehicle: Front Engine Dragster
Re: protecting tubing during build
« Reply #1 on: May 22, 2013, 05:28:48 PM »
Quote from: wideopen231 on May 22, 2013, 05:25:54 PM
While probably not a problem for Roo man,doubt he take 2 years to finish chassis. I need to put something on tubing to protect it during build.I can rub down with wd-40 or marvel mystery oil.I need somethine super easy to clean away for welding. Plus needs to be easy enough to wipe off before painting.  Any better ideas.
Those seem like two good options.
Logged
Glenn R. Lever
Rochester, New York 14617-2012
My Cars https://www.lever-family-racing.com/

Offline ts39256

  • Newbie
  • *
  • Posts: 29
    • View Profile
  • Your Vehicle: 1971 Mark Williams 210" FED
Re: protecting tubing during build
« Reply #2 on: May 22, 2013, 10:51:54 PM »
I have read about a protective spray called GIBBS. There is a write-up about it at http:/roadsters.com/gibbs/  I`ve never used it, but have heard it`s good. Its also listed at that auction site.
Logged
never blink, never lift

Offline coupemerc

  • Sr. Member
  • ****
  • Posts: 306
    • View Profile
  • Your Best Time: 3.86@188 (1/8 Mile), 5.97@233 (1/4 Mile)
Re: protecting tubing during build
« Reply #3 on: May 23, 2013, 04:35:18 PM »
X2 on the Gibbs! I used it on my bare chassis tubes and unpainted mag body over 6 months ago and it all still looks like new.
Logged
Pages: [1]   Go Up
« previous next »