Drag Racing Discussions > Front Engine Dragsters

New/Old Short Twin

<< < (2/2)

296moon:

--- Quote from: GlennLever on May 11, 2013, 07:24:50 PM ---I will follow this with interest.

--- End quote ---
I was going the cogs and chain route but when sourceing the the greek coupler for the trans to olds rear I found that MW does male and female blanks for oddball rears/trans applications so lightbulb time and we made these, will it work? I`ll let you know in september which is when I hope is its first run.

GlennLever:

--- Quote from: 296moon on May 12, 2013, 10:01:35 AM ---
--- Quote from: GlennLever on May 11, 2013, 07:24:50 PM ---I will follow this with interest.

--- End quote ---
I was going the cogs and chain route but when sourceing the the greek coupler for the trans to olds rear I found that MW does male and female blanks for oddball rears/trans applications so lightbulb time and we made these, will it work? I`ll let you know in september which is when I hope is its first run.

--- End quote ---

This would make a great build thread in the "Your Builds / Photo Gallery " http://www.frontenginedragsters.org/forum/index.php?board=15.0

Dolmetsch:
Looks good. All the best with your project. 455s area  great motor. GOBBBS of torque.
Don

buickfed:
looked at mw's site. couldn't find the part. do you have a part number?

Navigation

[0] Message Index

[*] Previous page