Social > Your Builds / Photo Gallery
Glenn's dragster thread
GlennLever:
--- Quote from: Paul New on February 05, 2016, 09:47:08 AM ---Oops thanks for the clarification
--- End quote ---
I wish you had been right, would have saved me some money
ricardo1967:
Nice goodies Glenn, I'm looking forward to see your car in action again with the new power plant.
PS.: Since your sourcing car and engine from Indy, you may want to considering moving here and we'll be neighbors ;)
coupemerc:
Glenn, just a thought...you may want to find out if those sleeves are removable and Darton may make a sleeve that will get you to a smaller bore.
GlennLever:
--- Quote from: ricardo1967 on February 05, 2016, 10:21:33 AM ---Nice goodies Glenn, I'm looking forward to see your car in action again with the new power plant.
PS.: Since your sourcing car and engine from Indy, you may want to considering moving here and we'll be neighbors ;)
--- End quote ---
When the dragster was built I commuted monthly for two years, I think the truck could almost drive there by itself
--- Quote from: coupemerc on February 05, 2016, 11:18:35 AM ---Glenn, just a thought...you may want to find out if those sleeves are removable and Darton may make a sleeve that will get you to a smaller bore.
--- End quote ---
Steel sleeves are hard to remove from an aluminum block.
The cost to do it out weights the cost of new pistons.
hotrodpete:
Soory Glenn, I also went to their site and glanced at the info. Those details like reading the entire description get me again.
on another thought, your builder now has a clean slate to make the best combo he can.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version