Social > Your Builds / Photo Gallery
Glenn's dragster thread
hotrodpete:
Hi Glenn, its been a long time since I posted. Always a quick check to see whats up.
Nice purchase on the block . It looks great. A quick look at the block specs show bore size 4.120 and up. Maybe your pistons could work, unless the longer rods change things.
On a side note, snobusters swap in Hamburg is this weekend. It is more a social than anything for us. Nice to hear what got done over the winter.
GlennLever:
--- Quote from: hotrodpete on February 05, 2016, 05:17:03 AM ---Hi Glenn, its been a long time since I posted. Always a quick check to see whats up.
Nice purchase on the block . It looks great. A quick look at the block specs show bore size 4.120 and up. Maybe your pistons could work, unless the longer rods change things.
On a side note, snobusters swap in Hamburg is this weekend. It is more a social than anything for us. Nice to hear what got done over the winter.
--- End quote ---
Where did you get the 4.120 number? I was told many different times by several different people block is delivered rough honed to 4.250 is
Paul New:
It shows it on the specs 4.120 - 4.400 bore, I took this off the web page listed in your post Glen
Sent from my iPhone using Tapatalk
GlennLever:
--- Quote from: Paul New on February 05, 2016, 06:35:10 AM ---It shows it on the specs 4.120 - 4.400 bore, I took this off the web page listed in your post Glen
Sent from my iPhone using Tapatalk
--- End quote ---
That is the Cast Iron Block, not the aluminum unfortunately.
Paul New:
Oops thanks for the clarification
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version