« previous next »
Pages: [1]   Go Down

Author Topic: Engine fitment  (Read 4541 times)

Offline rjracing

  • Newbie
  • *
  • Posts: 10
    • View Profile
Engine fitment
« on: May 02, 2013, 05:48:32 PM »
 >:(Well, trimming the block to work in chassis I found one some what expected oil galley and a totally unexpected water jacket.
Logged

Offline GlennLever

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 2010
    • View Profile
    • The Lever Family Site
  • Your Best Time: 1/4 mile 7.950 at 165 MPH
  • Your Engine: Pontiac 461 Alky Blown
  • Your Track: Empire Dragway, NY
  • Your Vehicle: Front Engine Dragster
Re: Engine fitment
« Reply #1 on: May 02, 2013, 08:45:05 PM »
Quote from: rjracing on May 02, 2013, 05:48:32 PM
>:(Well, trimming the block to work in chassis I found one some what expected oil galley and a totally unexpected water jacket.
woops.
Logged
Glenn R. Lever
Rochester, New York 14617-2012
My Cars https://www.lever-family-racing.com/

Offline ricardo1967

  • Hero Member
  • *****
  • Posts: 570
    • View Profile
  • Your Best Time: No full pass yet.
  • Your Engine: Alky SBC 400
  • Your Track: Brown County Dragway (Bean Blossom, IN)
  • Your Vehicle: 173" FED
Re: Engine fitment
« Reply #2 on: May 04, 2013, 09:00:36 AM »
Without too much hope, I have used J-B Weld on block repairs like this, so far so good.
Logged
Pages: [1]   Go Up
« previous next »