Author Topic: Looses oil pressure  (Read 3186 times)

Offline Guido

  • Newbie
  • *
  • Posts: 32
    • View Profile
  • Your Best Time: 7.52 185 mph
  • Your Engine: Supercharged sbc
  • Your Track: Kearney raceway park
  • Your Vehicle: 170" FED
  • General Location: Mid westMHRUWX
Looses oil pressure
« on: August 16, 2023, 05:38:59 AM »
I have a Dart little m block 400 Cid fresh build with a melling 10550st high volume oil pump and a 7qt pan. When I make a 1/4 mile pass it looses oil pressure the last hundred feet or so and after I let off it comes back. I go through the traps at 7800 rpm could it be sucking the pan dry?

Offline denverflatheader

  • Sr. Member
  • ****
  • Posts: 333
    • View Profile
Re: Looses oil pressure
« Reply #1 on: August 16, 2023, 08:06:38 AM »
Guido - you know what happens to your oil pressure when the car is moving to WOT.  Try it in the pits stationary and rpm up to 7800rpm and hold it there a few seconds to see if oil pressure drops off.  If it does, then you need to explore where the oil is sitting (i.e. valley or heads) and how to improve the restriction so it flows down faster to the oil pan. 

I'm guessing if it holds oil pressure constant at 7800rpm when stationary, then the issue is probably more related to your oil pan design.  Alan

Offline JEFF/21C

  • Full Member
  • ***
  • Posts: 122
    • View Profile
  • Your Best Time: N/A
  • Your Engine: 306 SBC INJECTED ALKY
  • Your Track: NONE
  • Your Vehicle: 23 T ALTERED
  • General Location: eastern canada
Re: Looses oil pressure
« Reply #2 on: August 16, 2023, 01:52:05 PM »
denverflatheader is most likely right, bad pan design,oil level to close to the crankshaft,or lack of oil control and if oil drains back from the top end and you have a good windage tray and oil pick-up placement and design. I've had problems with pans in the past.