Technical > Roo Man's Room
SFI chassis specs
Finnish Fireball:
Thanks Denver, picture lll.1.f shows the chassis bars numbered, and #2 is that center bar this spec sheet refers to. I totally agree 1" bar there oval or not is stupid. This can't be right.
Oldboy:
Maybe the important point is that all sizes mentioned in SFI specs. are 'minimum acceptable' sizes.
I guess that if the 1" dimension was 1.625" and the 0.857" was also 1.625" (i.e. round) that would be acceptable, or is that too simple?
I agree, all rather too complicated.
Finnish Fireball:
Oldboy got it right, it's just the minimum requirement and the current bigger tube is just fine. Case closed.
Navigation
[0] Message Index
[*] Previous page
Go to full version