Author Topic: Power glide pumping fluid from vent  (Read 6989 times)

Offline hemidakota

  • Full Member
  • ***
  • Posts: 210
    • View Profile
  • Your Best Time: 7.69 @ 173.5mph
  • Your Engine: 510 B1MC Wedge
  • Your Track: sacramento raceway
  • Your Vehicle: 02 200" fed
  • General Location: west coast
Power glide pumping fluid from vent
« on: December 20, 2019, 07:01:55 PM »
Well my cousin has a hughes glide in his racecar, never been ran. Had trans torn down by a builder to get case recert, trans guy reassembled. Started car for first time and it instantly started pumping fluid out of vent. Took back to builder and he said he put pump gasket in wrong and fixed it. Fired up car again and as I was adding fluid it started pumping out vent again so there is a problem still. I have built a few glides and never experienced this. Any ideas? He wants to take it back to builder but I think a 3rd time will not be fun. I want to tear it apart but don't really know what to look for. Any input would be greatly appreciated, Thanks
If it jams force it, if it breaks it needed replaced anyways

Offline masracingtd1167

  • Hero Member
  • *****
  • Posts: 1110
  • bill masiello Shelton Ct.
    • View Profile
  • Your Best Time: 7.40's at 181 on motor 6.94 at 192 nitrous
  • Your Engine: 394 chevy
  • Your Track: Lebanon Valley Dragway
  • Your Vehicle: 2003 Neil and Parks
Re: Power glide pumping fluid from vent
« Reply #1 on: December 22, 2019, 06:22:04 AM »
Double check the filter ! it could be on backwards ! Also some builders plug the cooler by pass at the pump so you must run a cooler of at least loop the line at the cooler fitting ! Valve body loose ? Broken or missing ring on input ? Let us know what you find . 

Offline gregm784

  • Sr. Member
  • ****
  • Posts: 384
    • View Profile
    • Means Racing
  • Your Engine: 365" GenIV SBC
  • Your Track: Famoso Raceway
  • Your Vehicle: 1997 Stirling 200" FED
Re: Power glide pumping fluid from vent
« Reply #2 on: December 23, 2019, 12:00:08 PM »
I highly recommend Jim @ ATO in Rancho Cordova.  He is a powerglide god. :) 
Greg
El Dorado County, CA
www.meansracing.com

Offline bikeguy307

  • Full Member
  • ***
  • Posts: 241
    • View Profile
Re: Power glide pumping fluid from vent
« Reply #3 on: December 25, 2019, 06:20:05 AM »
Im headed to the shop today, I will trace the vent circuit through the pump to find all possible cross feeds, sounds like an issue with the pump for sure.

Offline bikeguy307

  • Full Member
  • ***
  • Posts: 241
    • View Profile
Re: Power glide pumping fluid from vent
« Reply #4 on: December 25, 2019, 07:55:00 AM »
Definitely check your converter feed passages input shaft sealing rings and cooler passages in the pump all of these could directly cross feed into the vent circuit causing your issue.

Offline hemidakota

  • Full Member
  • ***
  • Posts: 210
    • View Profile
  • Your Best Time: 7.69 @ 173.5mph
  • Your Engine: 510 B1MC Wedge
  • Your Track: sacramento raceway
  • Your Vehicle: 02 200" fed
  • General Location: west coast
Re: Power glide pumping fluid from vent
« Reply #5 on: January 12, 2020, 09:09:12 PM »
Well trans came apart and pump gasket was again blown out. It is a new older hughes trans. It appears to be a JW case. JW said a paper gasket will not work and they sold my cousin a non blow gasket. Trans is reassembled and will be put back in tomorrow or next day. Will reply with results. And yes gasket was much better than a paper gasket...Thanks to all that answered
If it jams force it, if it breaks it needed replaced anyways

Offline bikeguy307

  • Full Member
  • ***
  • Posts: 241
    • View Profile
Re: Power glide pumping fluid from vent
« Reply #6 on: January 16, 2020, 08:34:31 AM »
Hope it takes care of the issue.

Offline gregm784

  • Sr. Member
  • ****
  • Posts: 384
    • View Profile
    • Means Racing
  • Your Engine: 365" GenIV SBC
  • Your Track: Famoso Raceway
  • Your Vehicle: 1997 Stirling 200" FED
Re: Power glide pumping fluid from vent
« Reply #7 on: January 16, 2020, 09:58:33 AM »
How much line pressure? i've seen over 275 and not have a gasket problem. As a matter of fact, i've never seen a gasket problem. 
Greg
El Dorado County, CA
www.meansracing.com

Offline hemidakota

  • Full Member
  • ***
  • Posts: 210
    • View Profile
  • Your Best Time: 7.69 @ 173.5mph
  • Your Engine: 510 B1MC Wedge
  • Your Track: sacramento raceway
  • Your Vehicle: 02 200" fed
  • General Location: west coast
Re: Power glide pumping fluid from vent
« Reply #8 on: January 17, 2020, 10:37:49 AM »
The gasket was blown at pressure port and fluid went around pump o-ring to vent port and blew gasket in is how it was venting. Old gasket was .040" and new gasket was .140". Will start it tonight and double check it. Is a crazy deal.
If it jams force it, if it breaks it needed replaced anyways

Offline gregm784

  • Sr. Member
  • ****
  • Posts: 384
    • View Profile
    • Means Racing
  • Your Engine: 365" GenIV SBC
  • Your Track: Famoso Raceway
  • Your Vehicle: 1997 Stirling 200" FED
Re: Power glide pumping fluid from vent
« Reply #9 on: January 17, 2020, 12:25:12 PM »
In doing that you just increased your end play in your trans .100" too.  I'm not a trans guy, not sure what that will affect.
Greg
El Dorado County, CA
www.meansracing.com

Offline hemidakota

  • Full Member
  • ***
  • Posts: 210
    • View Profile
  • Your Best Time: 7.69 @ 173.5mph
  • Your Engine: 510 B1MC Wedge
  • Your Track: sacramento raceway
  • Your Vehicle: 02 200" fed
  • General Location: west coast
Re: Power glide pumping fluid from vent
« Reply #10 on: January 18, 2020, 11:01:09 PM »
I just saw the gasket and helped put it back in and check it. I will post a pic of the gasket. Oh and it did not leak a drop this time...
If it jams force it, if it breaks it needed replaced anyways

Offline bikeguy307

  • Full Member
  • ***
  • Posts: 241
    • View Profile
Re: Power glide pumping fluid from vent
« Reply #11 on: January 21, 2020, 09:16:31 AM »
Glad the gasket cured your issue, but adding .100 to the end play is a huge amount, hope you adderssed this. The extra end play should be taken up from the rear inorder to keep the drum up on the pump correctly.

Offline JoydayVox

  • Full Member
  • ***
  • Posts: 139
    • View Profile
    • dapoxetine for premature ejaculation
  • Your Best Time: Urenulo
  • Your Engine: Ekubyboxe
  • Your Track: Ysehekol
  • Your Vehicle: Ijesu
  • General Location: Eweciq
Re: Power glide pumping fluid from vent
« Reply #12 on: November 11, 2024, 05:28:58 PM »
Yang IY, Miller H, Wang Z, Frank EG, Ohmori H, Hanaoka F, Moriya M <a href=https://fastpriligy.top/>priligy medication</a>