Author Topic: Nostalgia BBC Recipe  (Read 2819 times)

Offline tcoupekyle

  • Sr. Member
  • ****
  • Posts: 354
    • View Profile
  • Your Best Time: 4.70 1/8
  • Your Track: Houston Motorsport park
  • Your Vehicle: 225" slip joint FED
  • General Location: Houston
Nostalgia BBC Recipe
« on: December 24, 2020, 03:42:41 PM »
I once saw a write up on building a BBC tall deck motor on a budget. Online. But for the life of me can't find the article again. Anyone know where it's at? Or what I'm talking about.

Offline 225digger

  • Full Member
  • ***
  • Posts: 167
    • View Profile
  • Your Best Time: 7.43 185 mph in a RED
  • Your Track: numidia
Re: Nostalgia BBC Recipe
« Reply #1 on: December 24, 2020, 08:11:07 PM »
i think the link below is what your seeking ???

https://www.draglist.com/stories/SOD%20Apr%202001/SOD-042701.htm



.

Offline tcoupekyle

  • Sr. Member
  • ****
  • Posts: 354
    • View Profile
  • Your Best Time: 4.70 1/8
  • Your Track: Houston Motorsport park
  • Your Vehicle: 225" slip joint FED
  • General Location: Houston
Re: Nostalgia BBC Recipe
« Reply #2 on: December 25, 2020, 08:53:26 AM »
That's the one thank you so much!!

Offline Curly1

  • Sr. Member
  • ****
  • Posts: 260
    • View Profile
    • AireTex Compressors
  • Your Best Time: 7.95 @ 167 1/4 mile
  • Your Track: Texas Motorplex
  • Your Vehicle: 125" Altered
Re: Nostalgia BBC Recipe
« Reply #3 on: December 26, 2020, 06:10:11 PM »
That is a good article. A very low budget and simple motor that should perform good.

Offline fuel749

  • Full Member
  • ***
  • Posts: 159
    • View Profile
    • Dragster Supply
  • Your Track: New England Dragway
  • Your Vehicle: FED/Altered
Re: Nostalgia BBC Recipe
« Reply #4 on: December 27, 2020, 06:22:54 AM »
Anybody know what it ran in that dragster?

Offline Paul New

  • Hero Member
  • *****
  • Posts: 743
    • View Profile
  • Your Best Time: 6.47 @ 214 MPH SBC
  • Your Engine: 387" SBC
  • Your Track: Woodburn Dragstrip
  • Your Vehicle: 2005 FED
Re: Nostalgia BBC Recipe
« Reply #5 on: December 27, 2020, 06:12:54 PM »
This was his 7.50 engine which later turned into the 7.60 class