« previous next »
Pages: [1]   Go Down

Author Topic: pump sizing for blower  (Read 2308 times)

Offline wideopen231

  • Hero Member
  • *****
  • Posts: 1911
    • View Profile
  • Your Best Time: 1/8 3.70@ 198 1/4 5.78@245
  • Your Engine: Hemi 526 ci alcohol
  • Your Track: Piedmont
  • Your Vehicle: 225 CMC FED
  • General Location: NORTH CAROLINA
pump sizing for blower
« on: October 01, 2020, 05:48:21 PM »
 Looking at ton of guys running blower in bracket now and getting good results. Wondering what size pump required. Pretty sure my 1200's off TA stuff little big.  Then my little 6.8 gpm DSR seems small for anything much over very mild 6-71.
Logged
Relecting obama is like shooting right foot because it did not hurt enough when you shot left foot

Offline gregm784

  • Sr. Member
  • ****
  • Posts: 384
    • View Profile
    • Means Racing
  • Your Engine: 365" GenIV SBC
  • Your Track: Famoso Raceway
  • Your Vehicle: 1997 Stirling 200" FED
Re: pump sizing for blower
« Reply #1 on: October 08, 2020, 10:13:16 AM »
Seems to always come back to how much HP you wanna make. 

I run 16psi on my blown 387SBC.  1950#, 7.60/178mph.  i'm using about 5.3gpm. I run a DSR 80-a1 pump and still have lots of main jet to go.
Logged
Greg
El Dorado County, CA
www.meansracing.com

Offline wideopen231

  • Hero Member
  • *****
  • Posts: 1911
    • View Profile
  • Your Best Time: 1/8 3.70@ 198 1/4 5.78@245
  • Your Engine: Hemi 526 ci alcohol
  • Your Track: Piedmont
  • Your Vehicle: 225 CMC FED
  • General Location: NORTH CAROLINA
Re: pump sizing for blower
« Reply #2 on: October 17, 2020, 08:45:31 AM »
SOunds good. Already have DSR pump and would mean just need 6-71 that can deliver a lot of boost, but be run very mild with pump and just throw bigger system on for full bore power level if wanted.
Logged
Relecting obama is like shooting right foot because it did not hurt enough when you shot left foot
Pages: [1]   Go Up
« previous next »