« previous next »
Pages: [1]   Go Down

Author Topic: intake gasket sealing  (Read 3105 times)

Offline spookie

  • Jr. Member
  • **
  • Posts: 61
    • View Profile
  • Your Best Time: 8.92 1/4 5.59 1/8
  • Your Track: Quarter Aces drag-o-way
  • Your Vehicle: F.E.D.
intake gasket sealing
« on: October 11, 2020, 01:46:00 PM »
Getting ready to reinstall intake gasket on my sbc. Used permatex form a gasket on a fel-pro 1206 gasket,started to leak after first pass.Found form a gasket should not be used with alcohol!! What should I use? It may be intake and heads are not parallel,will check this week.If not parallel,what should I do?End rails get sealed with ultra gray.Thanks for any help.P.S. this a crower intake [old but flat].
Logged

Offline Draw 3D

  • Jr. Member
  • **
  • Posts: 71
    • View Profile
  • Your Engine: Blown Alky 406 SBC
  • Your Track: Wild Horse Pass
  • Your Vehicle: 1923 T Roadster
  • General Location: Arizona
Re: intake gasket sealing
« Reply #1 on: October 12, 2020, 07:27:04 AM »
I've been using Loctite 598 Black gasket maker on my blown alky SBC for years with no issues.
Logged

Offline BK

  • Sr. Member
  • ****
  • Posts: 310
    • View Profile
  • Your Best Time: 8.45 / 5.30
  • Your Track: Empire Dagway
  • Your Vehicle: Late 70's FED
Re: intake gasket sealing
« Reply #2 on: October 12, 2020, 05:40:00 PM »
I found that the Felpro Printoseal gaskets fit best in the garbage can.
Logged

Offline masracingtd1167

  • Hero Member
  • *****
  • Posts: 1110
  • bill masiello Shelton Ct.
    • View Profile
  • Your Best Time: 7.40's at 181 on motor 6.94 at 192 nitrous
  • Your Engine: 394 chevy
  • Your Track: Lebanon Valley Dragway
  • Your Vehicle: 2003 Neil and Parks
Re: intake gasket sealing
« Reply #3 on: October 22, 2020, 10:06:25 AM »
If your intake is not even with the head it will never seal right ! As far as gasket sealers go I would use the ultra black ! Never had an issue with it at all !
Logged

Offline OldSchoolHP

  • Newbie
  • *
  • Posts: 13
    • View Profile
  • Your Best Time: 8.92/158 - 1320'
  • Your Engine: 434 SBC
  • Your Track: AK Raceway Park
  • Your Vehicle: 125 Altered
  • General Location: Alaska
Re: intake gasket sealing
« Reply #4 on: October 27, 2020, 12:32:39 AM »
Check how tight the 1206 fits in there, if your heads were milled, and intake face is not correct you might check a 1266 which is double thick, if they are out of whack, the thick gasket will fail as well, but sometimes its enough to get them aligned and tightened up.
Logged
Pages: [1]   Go Up
« previous next »