Technical > Roo Man's Room

Motor plates

(1/2) > >>

janjon:
Does anyone know where I might find block bolt patterns, front and rear, for small block Chevy, for purposes of building engine plates? Any help appreciated.
John

GlennLever:

--- Quote from: janjon on April 05, 2013, 10:34:58 AM ---Does anyone know where I might find block bolt patterns, front and rear, for small block Chevy, for purposes of building engine plates? Any help appreciated.
John

--- End quote ---


This should help get you started.
This print shows the rear of the “Small Block Chevy” block including bell housing bolt hole pattern w/dimensioning including crank centerline etc.

wideopen231:
I use old power glide case for rear and set of threaded dead centers for front,simply screw then in and lay plate ofer them and tap with hammer.it makes perfect punh makrs fro drilling them. I guess you could do same on rear.  You can cheat and make a set in lathe or drill press,

janjon:
Thanks so much for the help and tips, Glenn and wideop.
John

janjon:
Might there be a similar drawing for SBC cylinder heads? Having to modify existing stud girdles to accept larger rocker nuts; there's some variation between center distances of the studs on the the heads, as measured, would be nice to know what it's "supposed to be". Any help appreciated, as always here.
John

Navigation

[0] Message Index

[#] Next page