« previous next »
Pages: [1]   Go Down

Author Topic: ron's fuel injection systems fuel pump  (Read 2711 times)

Offline Gonen60

  • Newbie
  • *
  • Posts: 1
    • View Profile
  • Your Best Time: 9.90 1/4
  • Your Engine: Sbf gasoline 302
  • Your Track: Elk creek dragway va
  • Your Vehicle: 72 maverick/ nostalgia a/a project getting started
  • General Location: Hillsville va
ron's fuel injection systems fuel pump
« on: December 07, 2019, 05:49:45 PM »
 Ron's fuel pump look similar to enderel and hilborn units, i traded for one of these 0 size pumps and haven't had it flow tested and was wondering if it would be compatible with a hilborn stack iintake system?
Logged

Offline jeff/21

  • Full Member
  • ***
  • Posts: 186
    • View Profile
  • Your Best Time: 8.24
  • Your Track: any with-in a 6hr radius
  • Your Vehicle: fed
Re: ron's fuel injection systems fuel pump
« Reply #1 on: December 09, 2019, 11:24:55 AM »
i too have the same question, 3 pumps 2 ron's, 1 hilborn with my sbc stack injectors can I switch them will interchange?Only the hilborn has been flowed they are all new
Logged

Offline wideopen231

  • Hero Member
  • *****
  • Posts: 1911
    • View Profile
  • Your Best Time: 1/8 3.70@ 198 1/4 5.78@245
  • Your Engine: Hemi 526 ci alcohol
  • Your Track: Piedmont
  • Your Vehicle: 225 CMC FED
  • General Location: NORTH CAROLINA
Re: ron's fuel injection systems fuel pump
« Reply #2 on: December 09, 2019, 07:59:30 PM »
Any pump will work with system.Only question is flow from one to other.I personally like to keep same style and size unless totally changing system. Even then flow characteristics  will effect tune up. If changing I would want to know flow of both old and new so as to make SWAG at starting point for tune.
Logged
Relecting obama is like shooting right foot because it did not hurt enough when you shot left foot
Pages: [1]   Go Up
« previous next »