Classifieds (Please No Dealers) > Wanted to buy

8mm pullies

(1/2) > >>

hotrod316:
looking for some 8 mm pullies  42 and a 60 something close to  25% under drive thanks

Paul New:
I do not have any for sale but a 42 top and a 60 bottom is 42% OD I may misunderstand your question though

hotrod316:
UNDERDRIVE  -25%  BIG ONE ON TOP,  LITTLE ONE ON THE BOTTON I THINK
ONLY WANT 2 MORE  LBS   

Paul New:
Ok 55 on top and a 44 on bottom gives you 25%UD or tons of other ways to get there. But I know most of the manufactured belt guards won’t fit a 60 tooth pulley on the top

gregm784:

--- Quote from: Paul New on August 07, 2019, 11:47:29 AM ---... But I know most of the manufactured belt guards won’t fit a 60 tooth pulley on the top

--- End quote ---

I can get a 58 on top, but unless the belt is SUPER tight, it'll candy stripe the back of it.

On a SBC with a RCD crank support, you can run down to a 53, but you have to relieve the I.D. of the lower pulley a tad bit. 

Navigation

[0] Message Index

[#] Next page