Author Topic: Idle Fuel Pressure  (Read 2880 times)

Offline Rat

  • Jr. Member
  • **
  • Posts: 65
    • View Profile
  • Your Best Time: 8.585 @ 154.55
  • Your Engine: Stack Injected All Iron 392 Chrysler Hemi
  • Your Track: Willowbank Raceway, Queensland, Australia
  • Your Vehicle: Colthup Bros FED
  • General Location: Australia - East Coast
Idle Fuel Pressure
« on: April 15, 2019, 06:08:49 AM »
Hi Spud, I know there are many variable but what approximate fuel pressure should we expect to see at idle.
392 Hemi, 6.5 GPM Hilborn pump, .034 nozzles, .125 Main with 22% leak down
Calculator shows around 110 psi at 8000 rpm.

Offline Spud Miller

  • Global Moderator
  • Sr. Member
  • *****
  • Posts: 332
    • View Profile
    • Fuel Injection Ent., LLC
Re: Idle Fuel Pressure
« Reply #1 on: May 23, 2019, 02:49:53 PM »

 If you're measuring on the nozzle side of the metering valve, you'll see "0" at idle on a gauge.

 On the pump side, it'll be in the 10-15 PSI at idle depending on how many PSI your main check valve is set at and typically, a main would be 1-2 PSI on a naturally aspirated setup.

If you run a 5-10 PSI main check valve, not only will your leakdown percentage be artificially low, but the idle fuel pressure on the pump side will be more like 15-25 PSI.

 Also, a secondary check valve (off your metering valve) could affect indicated idle fuel pressure. I typically set those about 18-20 PSI and that will limit things in the idle position.

 Spud

Fuel Injection Enterprises, LLC
     Mechanical Injection
     Magnetos
     EFI Conversions