advanced ET roller

[cad500justin]

Hey guys! I spent above my pay grade and built above my ability, now I have a motor that is capable of running faster than 7.50 but a chassis that isn't.
I'm looking for something fairly specific but shouldn't be too hard to find.

190-210" FED (225" wont fit in my trailer, unless you know someone that wants to buy my beater 24' trailer)
6.0 cert
able to accept a glide and with the availability to put a clutch in it.
the motor needs to be at least 38" out
9" rear preferred because i run odd gears 3.23

I have a sponsor that says he wants to put my car in his showroom and buy me another chassis.
supposedly nobody has gone faster than 7.30's with a Cadillac motor. hoping my new mill will do that on alcohol, but its built to run nostalgia A/fuel although i fully understand i don't have a chance against doc and drew. I'll most likely just run NE/1 but would like to reset that record on fuel.

Let me know if you have something and I'll send it to my sponsor.

Justin (925) 321-666one
located east of frisco.

[Paul New]

I would try to go with more than 38” out! Mine is 42” and the next car I build myself will be at least 47” out but will remain 200”

[dreracecar]

39" I have found is the minimum to use a full glide and directly plugging it in to the Ford 9". Motor placement is not as serious as people make it out to be.  Sometimes its better and quicker to have a new car built then trying to find and adapt to a used one, but they are less expensive.  A used 200" 6.0 cert chassis is going to be tough.   I think Billy McDevitt up in Concord has/had a car that fit your needs  I was Dennis Murphys (RIP)  car that ran 7.0 with a SBC, You can get ahold of him thru FB

[JrFuel Hayden]

Justin, I know of a few FED for sale , one is a roller JF car with out engine or powerglide, in Phoenix it has won NHRA Comp and Heritage races.
 I think his engine is out 44" with 225" WB, he also has a trailer that will take a 225 WB car. Also there is a JF roller for sale that will require some work, last time out the air bag under the car broke and some tubing will have to be replaced. I think its 185" WB with the engine location at 44" it was running a Ford so as with any car you get , you'll need motor plate and front mounts. This chassis is in the LA area, last I heard he wants under $5k. In Walnut Creek there is a JF 185"wb roller for sale racing the last two years the engine is 42" out I think.
So call me if any of that is interesting
Jon 805-444-4489

[cad500justin]

paul, i said 38" because my current car is 30-1/2" and id like to be able to pull the tranny without moving the frigging motor forward. but yes, 42-44-47 would be great!

I need to talk to billy, I've never actually hung out with him and he lives 45 minutes from me. I think he wants a little more than my sponsor is thinking dollar wise, but it sounds like its worth it.

Jon, if you could send me any info on that chassis in walnut creek, that sounds interesting.

[OldSchoolHP]

I like this post. Did you find a chassis?

[cad500justin]

@old school, I sure did!, i'll post some build pictures in another thread.