Drag Racing Discussions > Front Engine Dragsters

NOS fuel install...

<< < (2/2)

Roger:
Sounds like you have something similar to the photo. I used a #6 AN gauge adapter with a 1/4" pipe thread for a gauge on one side and on the other side the same fitting will be used for the RacePak fuel pressure sensor. Instead of the sensor, put a fitting in and attach your 4 AN line.

dusterdave173:
Perfect GROUNDS are a must! make sure that all wiring is soldiered and shrink wrapped--grounds must be perfect and reliable or you will have issues

noslin:

--- Quote from: dusterdave173 on January 26, 2019, 01:03:22 PM ---Perfect GROUNDS are a must! make sure that all wiring is soldiered and shrink wrapped--grounds must be perfect and reliable or you will have issues

--- End quote ---

100% what Duster Dave said, people overlook this and its the crux of a lot of issues people will have.  also, do not ground to the chassis.. you need floating grounds (and power) directly from the battery.

dusterdave173:
Yes many installs get low voltage To the solenoid so use correct gauge wire and TEST voltage at the solenoids when applied

SaltandPepper:
Thanks fellas, getting ready to run wire and plumb this week, good advice. I ordered another regulator and will run my fuel off the main line....will post pics when done.

Navigation

[0] Message Index

[*] Previous page