Drag Racing Discussions > Front Engine Dragsters
Budget rail
dreracecar:
current mild steel tubing wall is undersize for the spec and will not pass if the car must be stickered
dreracecar:
old school
Kentucky Mark:
Thanks for the info
speedbump:
Welcome back to the sport. If your planning on a fed. 9" ford or Mopar will be more then sufficient. The mopar would probable cost less. Biggest item of concern is to build your cage area wide, 20-21" at the shoulders. This will be one of your biggest resale issue if you ever want to sell in further. Just buy the book for the sfi chassis that you may want to run. or have some one build you the chassis so they can fit mtr. trans and rear in properly. well good luck and enjoy yourself.
JrFuel Hayden:
When you are ready for front wheels and tires, I may have some trade-ins on a deal.
Good Luck with your project I would advice you to listen Bruce Dyda, and Rooman
Jon Hansen, Hayden Wheels, 800-624-3803
Navigation
[0] Message Index
[*] Previous page
Go to full version