Author Topic: Gear set for a powerglide  (Read 3029 times)

Offline hemidakota

  • Full Member
  • ***
  • Posts: 210
    • View Profile
  • Your Best Time: 7.69 @ 173.5mph
  • Your Engine: 510 B1MC Wedge
  • Your Track: sacramento raceway
  • Your Vehicle: 02 200" fed
  • General Location: west coast
Gear set for a powerglide
« on: January 12, 2019, 06:59:42 PM »
I am building a 200" FED that should be pretty light. It will be a all aluminum Chrysler wedge in the 1000 to 1100 HP range. It is 510 ci, 4.5" bore 4" stroke. Stack injected alky deal with 3.150 butterflies that has been a very custom deal. Dam Chrysler has no good parts. It has a 3.89 Gear with a 31x12x15 slick. I will be ordering or building a powerglide for it. What gear set would all of you recommend? I am leaning toward a 1.69 so it will not be violent on the launch. I could go 1.80 but after a lot of research and talking to people the taller gear might be a better choice. What does everyone think? Thanks for the input.
Greg S.
« Last Edit: January 12, 2019, 07:01:30 PM by hemidakota »
If it jams force it, if it breaks it needed replaced anyways

Offline wideopen231

  • Hero Member
  • *****
  • Posts: 1911
    • View Profile
  • Your Best Time: 1/8 3.70@ 198 1/4 5.78@245
  • Your Engine: Hemi 526 ci alcohol
  • Your Track: Piedmont
  • Your Vehicle: 225 CMC FED
  • General Location: NORTH CAROLINA
Re: Gear set for a powerglide
« Reply #1 on: January 12, 2019, 08:32:07 PM »
1.69 is route I went. I fell into deal on coan  Max duty aluminum carrier with 1.69 and short shaft, sometimes shyt happens and its not bad,rare but it happens.
Relecting obama is like shooting right foot because it did not hurt enough when you shot left foot

Offline bikeguy307

  • Full Member
  • ***
  • Posts: 241
    • View Profile
Re: Gear set for a powerglide
« Reply #2 on: January 13, 2019, 06:46:33 PM »
I think you are on the right track going with 1.69. A 1.80 will be more prone to tire shake with that size tire.

Offline masracingtd1167

  • Hero Member
  • *****
  • Posts: 1110
  • bill masiello Shelton Ct.
    • View Profile
  • Your Best Time: 7.40's at 181 on motor 6.94 at 192 nitrous
  • Your Engine: 394 chevy
  • Your Track: Lebanon Valley Dragway
  • Your Vehicle: 2003 Neil and Parks
Re: Gear set for a powerglide
« Reply #3 on: January 14, 2019, 01:04:10 PM »
I would also say the 1.69 is the way to go ! I started with a 1.80 in mine and caused a lot of problems ! Switched to the 1.69 and picked up ET !